Cisco Exam Feedbacks of Students -SPOTO.

SPOTO always offer the 100% real and stable study material to our customers. This is the feedback of our customer’s  Cisco  Certification    exam feedbacks.

TS1 D3 H3

TS1

The important one is written in front. The TS is very smooth in the front. Later, it is stuck. It has been done for 1 hour and 20 minutes. There are still 3 and a half questions that don’t appear like it. It’s a bit cold. Fortunately, it can be adjusted in time, re-engineering ideas, and finally discharge three questions in time, sharing 1 hour and 55 minutes.

So the point: the preparation is full, especially Q5, Q8.you not only has to be second but also remember the relationship between the devices. The VPN part must pay attention to the fact that some letters are easy to read, passwords and the like.

Q1

The SW2 and R8 port MAC addresses are the same. If the PC101 MAC address is specified, shutdown, no shutdown is fine.

Q2

R17 s is less PPP IPCP default, just plus

Q3

R22 mask error changed to 248

Q4

R13 no prefix-list deny 145.14.14.14/32 just fine

R11-R14 is fully equipped with metric weight 0 1 1 1 1 1 Otherwise 1603/1703 is not right.

Q5

R22 IBGP does not set next-hop-self R21 prefix 194 does not write 194.1.0.0/16.

Q6

R25 network interface E0/0 prefix.

DIAG 3+

As with SPOTO, there is no need to describe it too much.

H3

The first test version is H3. At that time, ROUTERID of MPLS VPN did not pay attention, and many did not change it.

The most important ones are R14 and R51. If the VPN of R60 is stuck with IPSEC, it will not work, so there is no Tunnel Protect. Other phenomena are out. After the test results are out, it is clearly linked to this MPLS VPN chapter.

So, open the topology map, the big HollyMaya, my heart is still uneasy. I hope that it is H3 and I am afraid of getting stuck in the VPN.

Through this time I think H3 is not so mysterious, except for the Multicast multicast phenomenon. If you carefully check the pre-match, the SPOTO solution is reliable, generally no problem.

Layer 2 Technologies

The exam maps and tables are very detailed, and it can be done according to the map and the table.

VTP is off, but it is recommended to check or batch directly posted off

Layer 3 Technologies

OSPF comes pre-configured with many 65001 routers except that R13 is an ipv4 address cluster. Many commands can only be configured under the ipv4 address cluster.

VPN Technology

Not configured RD

OSPF has an ID by default, and the entire segment is declared.

MPLS Configure MPLS IP on the interface because the MPLS IP is configured on some interfaces.

DMVPN According to the standard configuration, note that the parameters of R14 and R51/R60 are the same. Last time I failed here, this time configuring DMVPN is very smooth.

There is nothing to say in the Internet section.

L2L can be configured according to R24, R24 is a dynamic map, R71 is equipped with the general.

Infrastructure Security and Infrastructure Services are exactly the same.