Exam Location：2019-10-16 HK
Starting with learning Lab：2019-6-13
CCIE's LAB road is hard to say, and it takes a few more words.
As a female student, one has a family to take the mouth, there are old and young, and there are young and irritated young women who work and husband. The time to squeeze out the version is very little. Going back to appease the child to sleep, it is already 10 o'clock in the night, after 10 o'clock is the time for me to study freely!
After entering the lab, I refused all the invitations from friends and canceled all the outing plans, only for the exam.
The feeling of this kind of effort is actually very good. I also hope that students who want to test IE should not give up. As long as you persist, no matter where you are, how many complicated things are around you, you can take the time to practice.
In the final week of the exam preparation, I was a thorough house girl, did not wash my face, and went directly to the simulation test. Throughout the lab, the gold content of the simulation test is the highest. I have added all the details of the simulation test that Mr. Chen changed, and the results are seconds.
One day before the test, you can look at this week's battle report and you can make a mistake.
Exam Package：13 plus3
Directly look at the 1014 Ono's passing report seconds the wrong point, the wrong point is almost the same! After half an hour, it is hard to check for half an hour, then point the end session.
After TS1 practiced the super metamorphosis version of SPOTO, you are invincible.。
Difficult point 1: E0/0 of SW2 does not release vlan12 (the same as 1014 Ono's wrong point)
Difficult point2: The authentication username of R17 is incorrect. On R12 is username UberMarket_spoke_R17 password 0 CCIE, on R17, is username UberMarket_spoke1_R17 password 0 CCIE, just change one.
Error1：R17 adds a PPP ipcp route default.
Error 1: R22 e 2/0 mask is wrong
Error 2: R21 router-id is wrong
Error 3: The R5 interface has IP OSPF cost, delete it.
Wrong point 1: Three routers need to be configured with metric Wei 0 1 1 1 1 1 (the same as 1014 Ono's wrong point)
Error 2: The R12 offset list does not reject the loopback of R14 (same point as 1014 Ono)
Wrong point 1: The lo0 port of R21 needs to be announced, 126.96.36.199 (the same as the error point of 1014 Ono)
Error 2: R4 and R6 are the same for the route MED of 188.8.131.52, change one or the smaller one (the same as 1014 Ono's wrong point)
DIAG3++ and 3++ mixed test, pay attention to distinguish between attackers and servers.
H3, do it here, the number has started to wave with you.
The requirements of H3 in the examination room are the same as in our data. Click on All Question and drag it to the right display. The top is topology.
Below is the Section requirement.
Focus on a few points:
1) The AS10000 area is in the first big-picture.........
2) The R42 OSPF area is ...........
3) e2/0-1 on SW510 is po2, and e2/2-3 is po1
5) LAN-2-LAN R71, nat is well equipped, ..... does not affect the phenomenon, the topic needs no special instructions, I have not changed.
6) DC1 OSPF must wait for the neighbor to be established before suppressing the prefix.
7) DMVPN,.........., make up.
8) About multicast, 2.10, option 2, SW10 announcement........
9) Need to pay attention to the details: ... seriously missing, each point, then shows run | sec router OSPF and show run | sec router BGP; part of the host is directly assigned an address, a part is obtained through DHCP, though... I still got the sentence, deleted
Others follow the SPOTO solution, and they are madly knocked, and the effect is completely matched. Check the details twice, end session.
Once I got out of the building, I received the mail.
In the previous battle report, I saw that this part always felt that they were the boss of SPOTO. Now I personally understand it, believe it, and get the number.
First, the theoretical class, shallow and deep, my network is white, learning from scratch, no pressure.
Second, Lab, Mr. Chen every time the information reply is late at night, deeply moved by this beautiful sister, it seems that SPOTO is very lacking in teaching assistants, if you need, please contact me, SPOTO Lab's update progress, information synchronization is definitely the most time in the whole network!
Third, in addition to a group of excellent teachers, teaching assistants, but also a group of enthusiastic classmates, thanks!
Finally, I wish you all the best in getting your number. As long as you have enough positive energy, don't be afraid of hardships, work hard, and lock up on SPOTO, you can take the number.
Note: if you want to get more Cisco certification exam information, and you can follow SPOTO where we will update the latest news. We have real exam answers and questions in accordance with the Cisco certification programs. CCIE LAB exam is stable, and you can take the exam before the Cisco program. if you have any questions, and you can join our WhatsApp Study Group: https://chat.whatsapp.com/FwQuSIDASCd7DHTDdIIcSa
More Recommended Articles