Free HP HPE7-A01 Practice Questions & Answers 2026 Part1 | Aruba Certified

Your manufacturing client is deploying twenty headless scanners in their warehouse.

What is true regarding 802.11k? 802.11k is a standard that provides mechanisms for APs and clients to dynamically measure the available radio resources in a wireless network. 802.11k defines radio resource management (RRM) functions, such as neighbor reports, link measurement, beacon reports, etc., that allow APs and clients to exchange information about the RF environment and make better roaming decisions. The other options are incorrect because they describe other standards, such as 802.11r, 802.11v, or 802.11ax. Reference: https://www.arubanetworks.com/assets/wp/WP_WiFi6.pdf https://www.arubanetworks.com/assets/ds/DS_AP510Series.pdf

In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

A company is in the planning stages to migrate to all their wireless domain laptops from WPA2 from WPA2 EAP-PEAP to EAP-TLS with machine Authentication. The administrator is testing a new Group Policy (GPO) that was pushed to only a few windows domain Laptops. The policy will configure the wireless profile to perform machine and certificate-based authentication. To support this new initiative the administrator also configured a new HPE Aruba Networking ClearPass 802.1X wireless service that only allows devices that successfully perform machine and certificate-based authentication. After successfully pushing the GPO, the Windows laptops are unable to join the configured ''secure_wireless'' SSID as shown below. Which configuration setting would resolve this issue? A) B) C) D)

What is an OSPF transit network?

you need to have different routing-table requirements With Aruba CX 6300 VSF configuration.Assuming the correct layer-2 VLAN already exists, how would you create a new SVI for a separate routing table?

What is true regarding 802.11k?

Which statement is correct for the HPE Aruba Networking Analytics Engine (NAE) in VSX environment?

With Aruba CX 6300. how do you configure ip address 10 10 10 1 for the interface in default state for interface 1/1/1?

How is Dynamic Multicast Optimization (DMO) implemented in an HPE Aruba Networking wireless network?

Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device The following configuration was created on the switch:A)B)C)D)

You are proposing new CX 8360 VSX switches to replace a customer's existing core switches.

Which statement best describes QoS?

A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working to a remote site connected via layer-3 All legacy devices are connected to a dedicated Aruba CX 6200 switch at each site. What technology on the Aruba CX 6200 could be used to meet this requirement? VXLAN is a technology that can be used to meet the requirement of using a legacy application that communicates at layer-2 across a layer-3 network. Static VXLAN is a feature that allows the creation of layer-2 overlay networks over a layer-3 underlay network using VXLAN tunnels. Static VXLAN does not require any control plane protocol or VTEP discovery mechanism, and can be configured manually on the Aruba CX 6200 switches. The other options are incorrect because they either do not support layer-2 communication over layer-3 network or are not supported by Aruba CX 6200 switches. Reference: https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/bk01-ch03.html https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/bk01-ch05.html

You are deploying a bonded 40 MHz wide channel What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

You are working on a network where the customer has a dedicated router with redundant Internet connections Tor outbound high-importance real-time audio streams from their datacenter All of this traffic.

Your Director of Security asks you to assign AOS - CX switch management roles to new employees based on their specific job requirements After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch. The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role Which default management role should have been assigned for the user?

For the Aruba CX 6400 switch, what does virtual output queueing (VOQ) implement that is different from most typical campus switches?

How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

Which statements regarding 0SPFv2 route redistribution are true for Aruba OS CX switches? (Select two.)

Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

What is a primary benefit of BSS coloring?

A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again.Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Select two.)

Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

A customer is looking Tor a wireless authentication solution for all of their loT devices that meet the following requirements

Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements. After the configuration was complete, it was noted that a user assigned with the auditors role did not have the appropriate level of access on the switch.The user was not allowed to perform firmware upgrades and a privilege level of 15 was not assigned to their role. Which default management role should have been assigned for the user?

Your customer is interested in hearing more about how roles can help keep consistent policyenforcement in a distributed overlay fabric How would you explain this concept to them''

A customer wants to find wireless clients indoors with meter-level accuracy by using supported Aruba APs as responders.

A customer wants to deploy a Gateway and take advantage of all the SD-WAN features. Which persona role option should be selected?

A company recently upgraded its campus switching infrastructure with Aruba 6300 CX switches. They have implemented 802.1X authentication on edge ports where laptop and loT devices typically connect An administrator has noticed that for PoE devices the pons are delivering the maximum wattage instead of what the device actually needs Upon connecting the loT devices, the devices request their specific required wattage through information exchange

How do you allow a new VLAN 100 between VSX pair inter-switch-link 256 for port 1/45 and 2/45?

Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

A customer has a site with 200 AP-515 access points 75AP-565 access points installed. The customer is rolling out new mobile phones with Wi-Fi-calling. 802.1X is in use for authenticationWhat should be enabled to ensure the best roaming experience?

Which statements regarding 0SPFv2 route redistribution are true for Aruba OS CX switches? (Select two.)

What is enabled by LLDP-MED? (Select two.)