After Experiencing in Cisco Changes in Exam, I Finally Got the CCIE Certified.

CCNA 200-301

CCNA 200-301

CCNP Enterprise

CCNP Enterprise

CCNP Security

CCNP Security

CCIE Enterprise Lab

CCIE Enterprise Lab

CCIE Security Lab

CCIE Security Lab

CCNP Service Provider

CCNP Service Provider

CCNP Data Center

CCNP Data Center

CCNP Collaboration

CCNP Collaboration

CCIE DC Lab

CCIE DC Lab

ic_r
ic_l
After Experiencing in Cisco Changes in Exam, I Finally Got the CCIE Certified.
images

Exam Seats: Brussels, 2019

Starting Time: 2019-8-12

The written test passed last year, and then the shoulder was injured, the physiotherapy and exercise, for half a year, until August this year, actually not very good.

However, if you do not take the written test, it will expire, and then the exam will be revised, but you still have to work hard to take the test.

After the registration, there will be no procrastination, no amateur life, no movies, TV, parties, dinners, all. I would like to thank my old lady and my wife for doing a great job of logistical support.

Throughout the review process, Mr. Chen from SPOTO, and all other teachers have done their best and tried to ask the boss of SPOTO to raise the salary again.

The specific review plan is basically based on the progress given by Teacher Chen. I took a ten-day leave before the test, which is still very useful.

I don't know what other siblings feel. After I practiced all the TS and CFG, I found a whole string. The content behind it was mastered, and the previous one was forgotten. All kinds of confusion, so there was actually no confidence in the ten days before the exam.

But it turns out that the previous exercises were not in vain. Before going to the examination room, they basically got through. For the first eight days of the whole day, I am basically two sets of TS, one set of CFG. CFG is not just a matter of knocking out. It is necessary to understand and master the ideas, and the way of routing. I think it is very helpful for later exams.

My main practice is to practice the H2 and H3 versions. H1+ and H2+ versions are all exercises that only do partition experiments. I personally understand that after the H2 and H3 versions are familiar, they will not change. (In fact, it’s blunt, it’s not enough time)

In the last two days, a one-day CFG partition experiment, one day, I wrote the problem-solving idea of TS. Free time, what to take a bath, before going to bed, brush your teeth, go to the bathroom, just look at the battle report and Diag.

I was in Brussels, so I wrote this chapter for the brothers in Brussels. 

The hotel I booked is the NH hotel, which provides an airport shuttle bus. The hotel's catering is actually OK, not so uncomfortable, of course, there is no heart to eat.

The hotel went to the test room of Cisco. Within 10 minutes, it was basically the door of the hotel. Turn left and go forward. You should see a map of the industrial park. Cisco is on the map with 3 buildings, 6A, 6B and 7C?

Then continue going forward, knowing to see a restaurant sign in a HIVE restaurant, turn left, go straight ahead, and you will be there.

The Cisco exam is waiting for 6A. In the morning, a group of people will wait there, and should not miss it.

The entire test room environment is still relatively relaxed, American Dell keyboard, two large monitors, I think it should be at least 24 inches, my home is, but I feel bigger than my family.

What red bull, tea, mug, biscuit, chocolate, earplugs (not headphones) can be brought. I also brought two wrist rests, the elderly, the speed of the hand, the reaction, and the slowness in all aspects. Tea, coffee, and go to the toilet.

During the exam process, TS and Diag are timed, TS can be handed over in advance, and Diag must wait for 30 minutes.

Then the teacher is based on the start time, deducting the lunchtime, plus 8 hours, unified timing. The last CFG part of the exam itself is not timed. In other words, if your TS is doing a good job and handing it in advance, then the time you save will be added to the CFG. (Only for the experience of the Brussels examination room!)

The temperature in the examination room was very comfortable. I wore a long-sleeved shirt, no cold, and no heat to sweat. Of course, just in case, it is better to bring a thin coat.

Section 2.1 TS

To be honest, I don't remember the mistakes, but if you figure out the versions and ideas of SPOTO, it is definitely no problem. I wrote down what I can remember.

I stuck on the fourth question DMVPN for four minutes. I was confused. The address of the R18 IP nhrp map multicast was wrong, but this time you use show dmvpn to see, Get up.

Moreover, the eigrp neighbor relationship can be seen on R18, but it can't be seen on R15. Later, the heart is going to do the next topic, and it's all done. Looking back, I can see it again.

Q1:

Error 1: 1: SW2 does not have vlan 12 created.

Q2:

Error 1: The authentication password of R17 is wrong. CCI on R12 and ccie on R17. Just change one.

Error 2: no off PPP callout.

Q3:

Error 1: The IP OSPF cost is done on the R3 interface, delete it.

I don’t remember the other mistakes.

Q4:

Error 1: metric Wei 0 1 1 1 1 1 for all four routers. If not configured, no FD1703

Error 2: The R12 offset list does not reject the loopback of R14

Q5:

Error 1: R21 did not write next-hope-self

Error 2: No max 2 is open on R12

Error 3: R1 has one LDP neighbor missing, which one does not remember

Q6:

Section 2.2

DIAG is a mixed test, which should be mixed with H3++ and H3+++. In fact, as long as you remember how to search for packages, basically other problems can not be wrong. There are video files in the group, you can refer to the next, there are also simulation packages, you can install Wireshark, feel your own.

Section 2.3

The basic test sites and peacetime exercises are similar. Several personal experience points:

1. the test site has a lot of pre-match, such as 65001 OSPF, there are many border routers BGP, have I checked the pre-complementary demand, you can also directly according to the demand brush, as long as the demand, the article Road to Rome

2. In the area of 65003,

    ..........this remember to add

3. I am not familiar with QoS and memory. I haven't touched it in my work. So I came up with the section first. Later, when I did that chapter in order, I tried to recall it. Next, I feel that under the pressure of the exam, I may not be able to do it. Personal advice, for this independent chapter, you are not familiar with the test sites, when you come up, you can take your mind to wake up, solve them first!

4. master the speed, in the usual practice, pay attention to it, almost how long each chapter is completed, try to adapt to the usual rhythm in the exam. I tend to prefer to slow down, but I am not wrong with the configuration, because the TR is always very uncomfortable.

5. I am all done, about 4 hours or so. Start the measurement phenomenon, in addition to the big phenomenon given in the title, it should also be noted that each user or server should be able to access the Internet, that is, ping 8.8.8.8, or ipv6 that 2001: ccie and the like of.

6. I just use this method, and later found two wrong points, even in the case that I am extremely careful not to make mistakes. The first point is how to ping nowhere, and later in accordance with the idea of ts, check the second layer, check the route. Layer-by-layer reaction

7.  the second point is mine, But the middle route shows that there is a loop bounce with each other, it is definitely not right, here I checked for a long time, there must be a loop, and finally found that it is mine,  caused a certain degree of the loop. After the change, the phenomenon is normal, save the file, 30 seconds later, the time is up, the exam is over.

8. just remember to keep it because in the end is uncertain, it took 5 minutes to re-save each device once.

The most profound experience of the whole exam is to adjust the mood in a timely manner. It is necessary to have a decisive decision to give up, but also to have the spirit of not fighting to the last moment, never give up, in the case of major phenomena.

If you see a wrong point and have time, don't give up the chance to miss the wrong point. Maybe it’s over, it’s just a bit of a mistake.

I used the usual TS idea to troubleshoot myself, from a direct connection, from second to third. Look at the routing plus table and check the access control. The wrong point will definitely be ruled out!

Finally, I wish everyone can pass the test and get their own number as soon as possible! Thanks again to all the teachers and all the students in the group! Special thanks to Mr.Zhang, your summary is very useful! 

Besides, we will have a special discount on Cisco Certification Exams Dumps. the following is the details:


More Recommended Articles

1. Which Part of CCIE Lab Exam Version Changes?

2. Hot! Rare CCIE Lab Seats Have Been Released! Book Now!

3. Some Strategies to Pass the CCIE Lab Certification Exam

4. CCIE DC Lab Exam Strategies from SPOTO's A Successful Candidate

5. CCIE Wireless Lab New CFG Comes, Which Part Change?