What does the Cisco DNA Center use to enable the delivery of applications through a network and to yield analytics for innovation?

An engineer must configure interface GigabitEthernet0/0 for VRRP group 10. When the router has the highest priority in the group, it must assume the master role. Which command set must be added to the initial configuration to accomplish this task? Initial Configuration interface GigabitEthernet0/0 description To IDF A 38-24-044.40 ip address 172.16.13.2 255.255.255.0

What does the error message relay to the administrator who is trying to configure a Cisco IOS device?

An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP logs in. Which configuration change is required?

Which router is the designated router on the segment 192.168.0.0/24?

Which two commands ensure that DSW1 becomes the root bridge for VLAN 10 and 20? (Choose two.)

An engineer is using XML in an application to send information to a RESTCONF-enabled device. After sending the request, the engineer gets this response message and an HTTP response code of 400. What do these responses tell the engineer?

R1 is able to ping the R3 fa0/1 interface. Why do the extended pings fail?

The inside and outside interfaces in the NAT configuration of this device have been correctly identified. What is the effect of this configuration?

Which two actions provide controlled Layer 2 network connectivity between virtual machines running on the same hypervisor? (Choose two.)

An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?

Which devices does Cisco DNA Center configure when deploying an IP-based access control policy?

Which command allows hosts that are connected to FastEthernet0/2 to access the Internet?

A network engineer configures a GRE tunnel and enters the show interface tunnel command. What does the output confirm about the configuration?

Wireless users report frequent disconnections from the wireless network. While troubleshooting, a network engineer finds that after the user is disconnected, the connection re-establishes automatically without any input required. The engineer also notices these message logs: AP 'AP2' is down. Reason: Radio channel set. 6:54:04 PM AP 'AP4' is down. Reason: Radio channel set. 6:44:49 PM AP 'AP7' is down. Reason: Radio channel set. 6:34:32 PM Which action reduces the user impact?

PC-1 must access the web server on port 8080. To allow this traffic, which statement must be added to an access control list that is applied on SW2 port G0/0 in the inbound direction?

What does the LAP send when multiple WLCs respond to the CISCO-CAPWAP-CONTROLLER.localdomain hostname during the CAPWAP discovery and join process?

Which command when applied to the Atlanta router reduces type 3 LSA flooding into the backbone area and summarizes the inter-area routes on the Dallas router?

Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?

Which two commands are needed to allow for full reachability between AS 1000 and AS 2000? (Choose two.)

A network administrator is preparing a Python script to configure a Cisco IOS XE-based device on the network. The administrator is worried that colleagues will make changes to the device while the script is running. Which operation of the ncclient manager prevents colleagues from making changes to the devices while the script is running?

Which type of antenna does the radiation pattern represent?

How does SSO work with HSRP to minimize network disruptions?

Which command must be applied to R2 for an OSPF neighborship to form?

An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configuration is not working. Which command set resolves this issue?