You are asked to deploy 802.1X on your EX Series switches. You need to ensure authenticated devices continue to have access to the network even if the authentication server fails. Which action meets this configuration objective?

Which two statements are true about IS-IS levels? (Choose two.)

Which two statements about OSPF routing policies are correct? (Choose two.)

You are designing a multicast topology to support IPv4 IPTV broadcasts in your organization. The design should support multiple multicast senders with overlapping group addresses while preventing interference between them. Client devices currently do not support IGMPv3. Which approach would fulfill these requirements?

Exhibit. Referring to the configuration shown in the exhibit, how many of the routes received from 10.0.0.2 will be active in the routing table?

Click the Exhibit button. You are adding VNI 101 to your EVPN-VXLAN network, but traffic is not being sent or received. Referring to the exhibit, which configuration statement will solve the problem?

You have configured class mode power management on an EX4300 to provide PoE power to telephone and security camera equipment. You want to ensure that security camera power takes priority over telephone power. Which two actions would solve this problem? (Choose two.)

Click the Exhibit button. Referring to the exhibit, the source is currently sending multicast traffic using group 224.1.1.1, which is being received by R1. R2 is not receiving PIM register messages. What would be the cause of this problem?

Click the Exhibit button. Referring to the exhibit, how is R5 able to learn the networks that exist within the NSSA?

What are three well-known mandatory BGP attributes? (Choose three.)

You are deploying IP phones in your Layer 2 network and are asked to ensure that the switch sends VLAN and CoS information to the IP phones automatically. In this scenario, which protocol should be used?

Your network is configured for EVPN load balancing on three different access switches During an outage, you notice that not all interfaces are receiving traffic as expected Which two requirements would you validate to identify this problem? (Choose two )

Which protocol is used for port-level access control and authentication?

You receive the same 100.200.0/16 route from all four ISPs to which you are connected. Referring to the exhibit, which ISP's route will be selected as active?

You are currently using VLAN IDs 2 through 300 within your Layer 2 domain and you need to configure VSTP to prevent loops You must ensure that all VL ANs are loop free. In this scenario, which statement is correct?

Which two statements are true regarding bidirectional PIM? (Choose two )

You are implementing 802.1x access control in your network of EX Series switches. You have some older client devices connecting to your network which do not support 802.1x. Which statement is true regarding the older devices?

What are two supported PoE management modes? (Choose two.)

In IS-IS advertising POUs with the overload bit has which effect?

Exhibit. You are implementing CoS for a custom application that is labeling its packets with DSCP code-point 101111. You have applied the configuration shown in the exhibit, but not that while some custom application traffic ingressin on ge-0/0/1 transits the SRX Series device successfully, packets ingressing all other ge-* interfaces are being dropped. Which action should you take to solve this problem?