Exhibit. Why is this OSPF adjacency remaining in this state? The exhibit shows the output of the commandshow ospf neighbor, which displays information about the OSPF neighbors on a router1. The output shows that the OSPF neighbor with the address 172.26.1.1 and the interface ge-0/0/3.0 is in the Exstart state1. The Exstart state is the fourth state in the OSPF neighbor formation process, after Down, Init, and 2-Way states2.In this state, the OSPF neighbors establish a master-slave relationship and exchange

Which statement is correct about the storm control feature? Option A is correct.The storm control feature is enabled in the factory-default configuration on EX Series switches12.On EX2200, EX3200, EX3300, EX4200, and EX6200 switches, the factory default configuration enables storm control for broadcast and unknown unicast traffic on all switch interfaces2.On EX4300 switches, the factory default configuration enables storm control on all Layer 2 switch interfaces1. Option B is incorrect.The storm control fea

After receiving a BGP route, which two conditions are verified by the receiving router to ensure that the received route is valid? (Choose two) Bis correct because the loops do not exist is one of the conditions that are verified by the receiving router to ensure that the received BGP route is valid.A loop in BGP means that a route has been advertised by the same AS more than once, which can cause routing instability and inefficiency1.To prevent loops, BGP uses the AS-path attribute, which lists the AS numb

Which two mechanisms are part of building and maintaining a Layer 2 bridge table? (Choose two.) Option B is correct.Flooding is a mechanism used in Layer 2 bridging where the switch sends incoming packets to all its ports except for the port where the packet originated1.This is done when the switch doesn't know the destination MAC address or when the packet is a broadcast or multicast1. Option C is correct.Learning is another mechanism used in Layer 2 bridging where the switch learns the source MAC addresse

Exhibit You are troubleshooting an issue where traffic to 192.168.10.0/24 is being sent to R1 instead of your desired path through R2. Referring to the exhibit, what is the reason for the problem? The exhibit shows the output of the commandshow ip bgp, which displays information about the BGP routes in the routing table1. The output shows two routes for the destination 192.168.10.0/24, one from R1 and one from R2. The route from R1 has a local preference of 200, while the route from R2 has a local preferen