لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
What is the maximum number of NET addresses supported on a virtual router?
A. 0
B. 1
C. 2
D. 3
عرض الإجابة
اجابة صحيحة: D
السؤال #2
Which configuration command causes a PPPoE subscriber to be connected to a captive portal?
A. url
B. motm
C. acName
D. sessions
عرض الإجابة
اجابة صحيحة: A
السؤال #3
Once the TCP connection is established, which message type initiates the BGP peering process?
A. Open
B. Active
C. Update
D. Notification
عرض الإجابة
اجابة صحيحة: A
السؤال #4
A log filter of log severity DEBUG pppPacket ATM 4/3.66 is configured within the category of pppPacket. Which configuration command removes this specific log filter?
A. no log severity pppPacket
B. no log severity debug pppPacket
C. no log severity pppPacket atm 4/3
D. no log severity debug pppPacket 4/3
عرض الإجابة
اجابة صحيحة: C
السؤال #5
Which CLI command is used to display the IP address assigned to Dynamic Subscriber Interface and related hardware address using the DHCP Relay Proxy function?
A. show ip dhcp external
B. show dhcp binding relay-proxy
C. show ip dhcp binding relay-proxy
D. show dhcp relay proxy binding
عرض الإجابة
اجابة صحيحة: B
السؤال #6
Which configuration command assigns a host route to the CPE workstation address of 192.168.10.1 in a Bridged 1483 network?
A. ip route 192
B. ip route 192
C. add route 192
D. add route 192
عرض الإجابة
اجابة صحيحة: A
السؤال #7
Which two routes do P routers see by default in a BGP MPLS VPN configuration? (Choose two.)
A. IGP routes advertised by P routers
B. IGP routes advertised by PE routers
C. VPN routes advertised by PE routers
D. VPN routes advertised by CE routers
عرض الإجابة
اجابة صحيحة: AB
السؤال #8
Which CLI command displays the IS-IS level used by each interface?
A. show clns neighbor
B. show isis neighbor
C. show clns interface
D. show isis interface
عرض الإجابة
اجابة صحيحة: C
السؤال #9
Two Level 1 routers are exchanging Hello packets with different Area IDs. What occurs between these routers?
A. An Adjacency is formed
B. No IS-IS PDUs are sent
C. An Adjacency does not form
D. An Adjacency forms but traffic is not forwarded
عرض الإجابة
اجابة صحيحة: C
السؤال #10
You would like to configure a fractional T1 interface on a channelized T3 controller with the following properties: ? Slot - 4 ? Port - 1 #2 ? DS0 - 1-12 ? Speed - 64 bps Which set of configuration commands accomplishes this goal?
A. controller t3 1/4 t1 1/2 dso 1-12 speed 64
B. controller t3 1/4 t1 1/2 timeslots 1-12 speed 64
C. controller t3 4/1 t1 2/1 dso 1-12 speed 64
D. controller t3 4/1 t1 2/1 timeslots 1-12 speed 64
عرض الإجابة
اجابة صحيحة: D
السؤال #11
If all OSPF routers on a broadcast network have the same OSPF priority, which parameter is used to determine the new BDR at the time of a DR failure?
A. area ID
B. router ID
C. loopback address
D. IP address of interface on broadcast network
عرض الإجابة
اجابة صحيحة: B
السؤال #12
Where are Level 1 LSPs flooded?
A. over all physical links
B. over all Level 1 adjacencies
C. over all Level 1 and Level 2 adjacencies
D. over all Level 1 and Level 2 adjacencies within the IS-IS domain
عرض الإجابة
اجابة صحيحة: B
السؤال #13
Which CLI command is used to display BGP-learned routes that are now in the OSPF link-state database?
A. show ip ospf neighbors
B. show ip ospf database router
C. show ip ospf remote-neighbors
D. show ip ospf database external
عرض الإجابة
اجابة صحيحة: D
السؤال #14
You are trying to recover from a corrupted flash. Which configuration command configures an IP address of 192.168.1.1/24 on the SRP management interface when the ERX1400 router is at the boot## prompt?
A. ip address 192
B. ip address 192
C. ip address 192
D. ip address 192
عرض الإجابة
اجابة صحيحة: C
السؤال #15
Which CLI command shows whether an L2TP Tunnel Switch profile is applied?
A. l2tp tunnel test
B. show subscribers
C. show aaa domain-map
D. show l2tp destination profile
عرض الإجابة
اجابة صحيحة: C
السؤال #16
Which configuration command permits dynamic detection of the ATM frame format?
A. aal5mux
B. aal5snap
C. aal5dynamic
D. aal5autoconfig
عرض الإجابة
اجابة صحيحة: D
السؤال #17
Which set of configuration commands configures MBGP on the ERX Edge Router?
A. router bgp 100 neighbor 192
B. router bgp 100 neighbor 192
C. router bgp 100 neighbor 192
D. router bgp 100 neighbor 192
عرض الإجابة
اجابة صحيحة: D
السؤال #18
When does the E-series router start monitoring DHCP traffic using the DHCP External function?
A. When the discovery packet enters the router from the DHCP client
B. Only when the offer packet enters the router from the DHCP server
C. When the acknowledge packet enters the router from the DHCP server
D. Only when the discovery packet leaves the router going to the DHCP server
عرض الإجابة
اجابة صحيحة: D
السؤال #19
Which interface tunnel parameter allows an LSP to use a specified explicit route?
A. path-option
B. route-option
C. explicit-path-option
D. explicit-route-option
عرض الإجابة
اجابة صحيحة: A
السؤال #20
An ATM PVC is configured as atm pvc 33 0 33 aal5snap 256. What does the 256 option specify?
A. CBR with a peak rate of 256K bits per second
B. UBR with a peak rate of 256K bits per second
C. CBR with a peak rate of 256K bytes per second
D. UBR with a peak rate of 256K bytes per second
عرض الإجابة
اجابة صحيحة: B
السؤال #21
By default, how often does an ERX Edge Router send an OSPF link-state advertisement in a stable network?
A. every 10 seconds
B. every 30 seconds
C. every 10 minutes
D. every 30 minutes
عرض الإجابة
اجابة صحيحة: D
السؤال #22
How may L2TP tunnel destinations are allowed per domain?
A. 1
B. 11
C. 21
D. 31
عرض الإجابة
اجابة صحيحة: D
السؤال #23
Which term describes a group of packets sharing common forwarding characteristics?
A. common forwarding class
B. forwarding equivalence class
C. equivalent class characteristics
D. forwarding class characteristics
عرض الإجابة
اجابة صحيحة: B
السؤال #24
What are three ways an IP interface can be assigned to a virtual router in a PPP over ATM environment? (Choose three.)
A. profile
B. policy list
C. domain map
D. RADIUS VSA
E. classifier ACL
عرض الإجابة
اجابة صحيحة: ACD
السؤال #25
Which set of commands configures a PPPoE interface and pushes http ://www.isp1home.com as a URL to the user's PC?
A. interface fastethernet 3/1 pppoe url http://www
B. interface fastethernet 3/1 pppoe url http://www
C. interface fastethernet 3/1 pppoe pppoe subinterface fastethernet 3/1
D. interface fastethernet 3/1 pppoe pppoe subinterface fastethernet 3/1
عرض الإجابة
اجابة صحيحة: D
السؤال #26
Which three can be specified within an RSVP session attribute object? (Choose three.)
A. hold priority
B. setup priority
C. FEC IP address
D. resource availability
E. local protection option
عرض الإجابة
اجابة صحيحة: ABE
السؤال #27
Which two functions can be configured on the ERX Edge Router to support MBGP? (Choose two.)
A. address-family ipv4 unicast
B. address-family vpnv4 unicast
C. address-family ipv4 multicast
D. address-family vpnv4 multicast
عرض الإجابة
اجابة صحيحة: BC
السؤال #28
During OSPF adjacency formation, in which state is a router in when an OSPF hello packet has been sent but bi-directional communication has not been achieved?
A. Init
B. 2Way
C. ExStart
D. Exchange
عرض الإجابة
اجابة صحيحة: A
السؤال #29
You would like to operate IS-IS on interface atm 6/0.33 with an IP address of 192.168.1.1/24. Which set of commands accomplishes this?
A. router isis network 192
B. router isis network 192
C. interface atm 6/0
D. interface atm 6/0
عرض الإجابة
اجابة صحيحة: D
السؤال #30
Which OSPF router type summarizes network advertisements from one OSPF area into another?
A. ABR
B. ASBR
C. edge router
D. backbone router
عرض الإجابة
اجابة صحيحة: A

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.