A technician is connecting multiple switches to create a large network for a new office. The switches are unmanaged Layer 2 switches with multiple connections between each pair. The network is experiencing an extreme amount of latency. Which of the following is MOST likely occurring?

A network technician is installing an analog desk phone for a new receptionist After running a new phone line, the technician now needs to cnmp on a new connector. Which of the following connectors would MOST likely be used in this case?

The following instructions were published about the proper network configuration for a videoconferencing device: "Configure a valid static RFC1918 address for your network. Check the option to use a connection over NAT." Which of the following is a valid IP address configuration for the device?

A technician is installing a new fiber connection to a network device in a datacenter. The connection from the device to the switch also traverses a patch panel connection. The chain of connections is in the following order: Device LC/LC patch cable Patch panel Cross-connect fiber cable Patch panel LC/LC patch cable Switch The connection is not working. The technician has changed both patch cables with known working patch cables. The device had been tested and was working properly before being installed. Wh

An IDS was installed behind the edge firewall after a network was breached. The network was then breached again even though the IDS logged the attack. Which of the following should be used in place of these devices to prevent future attacks?

A technician is connecting DSL for a new customer. After installing and connecting the on-premises equipment, the technician verifies DSL synchronization. When connecting to a workstation, however, the link LEDs on the workstation and modem do not light up. Which of the following should the technician perform during troubleshooting?

A network administrator needs to query the NSs for a remote application. Which of the following commands would BEST help the administrator accomplish this task?

A company wants to set up a backup data center that can become active during a disaster. The site needs to contain network equipment and connectivity. Which of the following strategies should the company employ?

Several users with older devices are reporting intermittent connectivity while in an outdoor patio area. After some research, the network administrator determines that an outdoor WAP might help with the issue. However, the company does not want the signal to bleed into the building and cause interference. Which of the following should the network administrator perform to BEST resolve the issue?

Which of the following will reduce routing table lookups by performing packet forwarding decisions independently of the network layer header?

There are two managed legacy switches running that cannot be replaced or upgraded. These switches do not support cryptographic functions, but they are password protected. Which of the following should a network administrator configure to BEST prevent unauthorized access?

Which of the following documents would be used to define uptime commitments from a provider, along with details on measurement and enforcement?

Which of the following is a system that is installed directly on a server's hardware and abstracts the hardware from any guest machines?

A network engineer needs to reduce the overhead of file transfers. Which of the following configuration changes would accomplish that goal?

A network device is configured to send critical events to a syslog server; however, the following alerts are not being received: Severity 5 LINK-UPDOWN: Interface 1/1, changed state to down Severity 5 LINK-UPDOWN: Interface 1/3, changed state to down Which of the following describes the reason why the events are not being received?

An organization is interested in purchasing a backup solution that supports the organization's goals. Which of the following concepts would specify the maximum duration that a given service can be down before impacting operations?

A network technician has determined the cause of a network disruption. Which of the following is the NEXT step for the technician to perform?

A PC and a network server have no network connectivity, and a help desk technician is attempting to resolve the issue. The technician plans to run a constant ping command from a Windows workstation while testing various possible reasons for the connectivity issue. Which of the following should the technician use?

A network technician is manually configuring the network settings for a new device and is told the network block is 192.168.0.0/20. Which of the following subnets should the technician use?