Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

Refer to exhibits. Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members. Based on the exhibits, which statement is correct?

The exhibit shows the SD-WAN rule status and configuration. Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?

Which two statements about SD-WAN central management are true? (Choose two.)

Exhibit B – Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate. Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

What is the route-tag setting in an SD-WAN rule used for?

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups. Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)

Exhibit. Which conclusion about the packet debug flow output is correct?

Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)

Refer to exhibits. Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN interface and the static routes configuration. Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds. Which statement about the dead member is correct?

Which are two benefits of using CLI templates in FortiManager? (Choose two.)

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

Refer to the exhibits. Exhibit A Exhibit B - Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status. The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule. Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?

Refer to exhibits. Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy. The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy. Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two.)

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0. Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)