لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?
A. Use an extended access list instead of a standard access list
B. Change sequence 10 in the route-map command from permit to deny
C. Use a prefix list instead of an access list in the route map
D. Add this statement to the route map: route-map RM-OSPF-DL deny 20
عرض الإجابة
اجابة صحيحة: D
السؤال #2
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)
A. Copy the file to the destination router with the copy tftp: flash: command
B. Enable the TFTP server on the source router with the tftp-server flash: command
C. TFTP is not supported in recent IOS versions, so an alternative method must be used
D. Configure a user on the source router with the username tftp password tftp command
E. Configure the TFTP authentication on the source router with the tftp-server authentication local command
عرض الإجابة
اجابة صحيحة: AB
السؤال #3
Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?
A. shared risk link group-disjoint
B. linecard-disjoint
C. lowest-repair-path-metric
D. interface-disjoint
عرض الإجابة
اجابة صحيحة: A
السؤال #4
Which transport layer protocol is used to form LDP sessions?
A. UDP
B. SCTP
C. TCP
D. RDP
عرض الإجابة
اجابة صحيحة: C
السؤال #5
A router receiving BGP routing updates from multiple neighbors for routers in AS 690. What is the reason that the router still sends traffic that is destined to AS 690 to a neighbor other than 10.222.1.1?
A. The local preference value in another neighbor statement is higher than 250
B. The local preference value should be set to the same value as the weight in the route map
C. The route map is applied in the wrong direction
D. The weight value in another statement is higher than 200
عرض الإجابة
اجابة صحيحة: B
السؤال #6
Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?
A. router ospfv3 1address-family ipv4
B. Router(config-router)#ospfv3 1 ipv4 area 0
C. Router(config-if)#ospfv3 1 ipv4 area 0
D. router ospfv3 1address-family ipv4 unicast
عرض الإجابة
اجابة صحيحة: B

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.