لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت

السؤال #1
Refer to the exhibit: Which effect of this configuration is true?
A. it creates a pseudowire class named Cisco
B. It enables tagging for VLAN 12 on the interface
C. It enables MPLS on the interface
D. It enables AToM on interface gigabitethemet1/0
عرض الإجابة
اجابة صحيحة: B
السؤال #2
What are the two uses of the YANG data modeling language? (Choose two.)
A. It is used to access a device by HTTP
B. It Is used to model the configuration used by NETCONF operations
C. It is used to shape state data of network elements
D. It Is used to replace RESTCONF as a mechanism to install and manipulate configuration
E. It is used to replace the OSI model for troubleshooting
عرض الإجابة
اجابة صحيحة: D
السؤال #3
How can a network administrator secure rest APIs?
A. They can allow read and write privileges to all users
B. They can ensure that user sessions are authenticated using TACACS+ only
C. They can have a general administrator login for multiple users to access that has command entries logged
D. They can authenticate user sessions and provide the appropriate privilege level
عرض الإجابة
اجابة صحيحة: C
السؤال #4
A network engineer is implementing OSPF multiarea. Which command on interface GO/1 resolves adjacency issues in the new area?
A. ip ospf network broadcast
B. ip ospf network point-to-point
C. ip ospf network non-broadcast
D. ip ospf network point-to-multipoint
عرض الإجابة
اجابة صحيحة: B
السؤال #5
An engineer must implement QoS to prioritize traffic that requires better service throughout the network. The engineer started by configuring a class map to identify the high-priority traffic. Which additional tasks must the engineer perform to implement the new QoS policy?
A. Attach the class map to a policy map that sets the minimum bandwidth allocated to the classified traffic and designates the action to be taken on the traffic
B. Attach the class map to a policy map that designates the action to be taken on the classified traffic and then attach the policy map to an interface using a service policy
C. Attach the class map to a policy map within a VRF to segregate the high-priority traffic and then attach the policy map to an interface in another VRF
D. Create a route map to manipulate the routes that are entered into the routing table and then attach the route map to an interface using a service policy
عرض الإجابة
اجابة صحيحة: D
السؤال #6
What is a characteristic of the YANG model?
A. Associate types are optional for each leaf
B. It uses containers to categorize related nodes
C. It is a distributed model of nodes
D. Spines are used to represent individual attributes of nodes
عرض الإجابة
اجابة صحيحة: C
السؤال #7
How do intent APIs make it easier for network engineers to deploy and manage networks?
A. Option A
B. Option B
C. Option C
D. Option D
عرض الإجابة
اجابة صحيحة: D
السؤال #8
When Cisco lOS XE REST API uses HTTP request methods what is the purpose of a PUT request?
A. retrieves the specified resource or representation
B. submits data to be processed to the specified resource
C. updates the specified resource with new information
D. creates a new resource
عرض الإجابة
اجابة صحيحة: B
السؤال #9
A network operator needs to implement PIM-SSM multicast configuration on customer's network so that users in different domains are able to access and stream live traffic. Which two actions must the engineer perform on the network to make the streaming work? (Choose two.)
A. Configure at least one MSDP peer on the network
B. Enable IGMP version 2 at the interface lever
C. Enable PIM sparse mode on the device
D. Enable IGMP version 3 at the interface level
E. Enable PM dense mode on the device
عرض الإجابة
اجابة صحيحة: A
السؤال #10
Which control plane protocol is used between Cisco SD-WAN routers and vSmart controllers?
A. OTCP
B. OMP
C. UDP
D. BGP
عرض الإجابة
اجابة صحيحة: D
السؤال #11
An engineer is configuring two routers to support MPLS LDP sessions between them. The R1 configuration is complete, and work has started on R2 as shown. Which additional configuration must the engineer apply to R2 to complete the task?
A. Option A
B. Option B
C. Option C
D. Option D
عرض الإجابة
اجابة صحيحة: D
السؤال #12
A network architect décides to expand the scope of the multicast deployment within the company network the network is already using PlM-SM with a static RP that supports a high-bandwidth. video-based training application that s heavily used by the employees, but excessive bandwidth usage is a concern How must the engineer update the network to provide a more efficient multicast implementation'?
A. Configure IGMP to manage the multicast hosts on each LAN
B. implement BSR to support dynamic RP notification
C. Deploy ICMP to Improve multicast reachability across the network using static RP
D. Implement STP to improve switching performance for multicast data
عرض الإجابة
اجابة صحيحة: B
السؤال #13
Which function does RSVP perform in a Cisco MPLS TE environment?
A. It establishes targeted LDP sessions between neighbors that are directly connected
B. It signals to LDP protocol along the path that a Cisco MPLS TE will be configured
C. It reserves bandwidth for LDP sessions between routers participating in a Cisco MPLS TE
D. It reserves the bandwidth along the path between the head-end and tail-end router
عرض الإجابة
اجابة صحيحة: C
السؤال #14
What is the difference between SNMP and model-driven telemetry?
A. Telemetry allows for modeled network data to be pushed to the network administrator on an as-needed basis
B. Telemetry uses traps and inform messages to deliver data to a network administrator on a polling basis
C. SNMP uses the YANG data modeling language
D. SNMP pushes network data to the network administrator whenever it is queried
عرض الإجابة
اجابة صحيحة: A
السؤال #15
The network-engineering team of a service provider is integrating several recently acquired networks into a more scalable common Unified MPLS architecture. The new network architecture will support end-to-end VPNv4 and VPNv6 services with these requirements: ? The IGP of the core layer is IS-IS In Area 0. ? The IGP of the aggregation layers is OSPF in Area 0. ? The LDP protocol Is used to distribute label bindings within each IGP domain. Which task must the network engineer perform when implementing this ne
A. Configure BGP-LU between ABR routers of each IGP domain to carry MPLS label information in NLRI
B. Configure a BGP session between the ABR routers of each IGP domain to exchange VPNv4 or VPNv6 prefixes
C. Configure the ABR in each IGP domain to preserve next-hop information on all VPNv4 and VPNv6 prefixes advertised by the PE
D. Configure mutual redistribution of each IGP domain's loopback prefix to provide end-to-end LDP LSP
عرض الإجابة
اجابة صحيحة: C
السؤال #16
What does the script configure?
A. a VLAN namespace
B. selectors for the in-band management
C. a physical domain
D. a static VLAN
عرض الإجابة
اجابة صحيحة: C
السؤال #17
Guidelines This is a lab item in which tasks will be performed on virtual devices. ? Refer to the Tasks tab to view the tasks for this lab item. ? Refer to the Topology tab to access the device console(s) and perform the tasks. ? Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window. ? All necessary preconfigurations have been applied. ? Do not change the enable password or hostname for any device. ? Save your configurations to NVRAM be
A. Mastered
B. Not Mastered
عرض الإجابة
اجابة صحيحة: D
السؤال #18
An engineer implemented OSPF neighbor relationship on an IOS device. Which configuration must be applied to get the OR/BOR election removed from interfaces running OSPF?
A. ip ospf network broadcast on interfaces running OSPF
B. ip ospf network point-to-point on interfaces running OSPF
C. ip ospf network multipoint-point on interfaces running OSPF
D. ip ospf network non-broadcast on n:erfaces running OSPF
عرض الإجابة
اجابة صحيحة: CD
السؤال #19
Refer to the exhibit. An organization s network recently experienced several significant outages due to device failures. The network administrator just moved the network devices to a new central data center, and packets are switched using labels. The administrator Is now implementing NSF on the network to reduce potential risk factors in the event of another outage. Which task must the administrator perform on each router as part of the process?
A. Remove route filtering to speed repopulation of the link-state database
B. Copy the router s existing state information and share the file with its peers to enable BGP soft resets
C. Implement MPLS to forward packets while the RIB updates after a faliover
D. Implement Graceful Restart to mitigate the delay in MPLS LDP synchronization when the IGP starts up
عرض الإجابة
اجابة صحيحة: B
السؤال #20
Refer to the exhibit: R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1. these log messages are seen. Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?
A. ip ospf network non-broadcast
B. ip ospf network point-to- multipoint non-broadcast
C. ip ospf network point-to-point
D. ip ospf network broadcast
عرض الإجابة
اجابة صحيحة: AD
السؤال #21
An engineering team must implement Unified MPLS to scale an MPLS network. Devices in the core layer use different IGPs, so the team decided to split the network into different areas. The team plans to keep the MPLS services as they are and introduce greater scalability. Which additional action must the engineers take to implement the Unified MPLS?
A. Redistribute the IGP prefixes from one IGP into the other routers to ensure end-to-end LSPs
B. Configure the ABR routers as route reflectors that redistribute IGP into BGP
C. Redistribute the IGP prefixes into another IGP to ensure end-to-end LSPs
D. Move the IGP prefixes into IS-IS as the loopback prefixes of the PE routers to distribute the prefixes to other routers to create end-to-end LSPs
عرض الإجابة
اجابة صحيحة: D
السؤال #22
How is a telemetry session established for data analytics?
A. A router initiates a session using the dial-out to a destination
B. A destination initiate a session to a router
C. The destination initiate a session using the dial-out more to the router
D. A router requests the data using Teinet
عرض الإجابة
اجابة صحيحة: BC
السؤال #23
Refer to the exhibit: What does the REST API command do?
A. It retrieves the information requested by Descriptions xml
B. It removes the information identified by Descriptions xml
C. It executes the commands specified in Descriptions xml
D. It displays the information identified by Descriptions xml
عرض الإجابة
اجابة صحيحة: C
السؤال #24
Refer to the exhibit: Which two statements about the ISIS topology are true? (Choose two.)
A. All four routers are operating as Level 1 routers only
B. All four routers are operating as Level 2 routers only
C. All four routers are operating as Level 1-2 routers
D. R1 and R2 are Level 2 neighbors
E. R1 and R4 are Level 2 neighbors
عرض الإجابة
اجابة صحيحة: AE

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف: