Which of the following cannot be used to connect an OSPF nonbackbone area to the backbone area? (Select the best answer.)

Topic 1Which component handles the orchestration plane of the Cisco SD-WAN?

Topic 1Which benefit is offered by a cloud infrastructure deployment but is lacking in an on-premises deployment?

You administer the network in the following exhibit: All routers are configured to the system MTU defaults. You issue the ping 192.168.1.2 size 1500 dfbit command from RouterB, but the ping fails. Which of the following is most likely the cause of the failure? (Select the best answer.)

Topic 1Where is radio resource management performed in a Cisco SD-Access wireless solution?

Which of the following is not a GRE tunnel state on a Cisco device? (Select the best answer.)

Topic 1What is the role of the vSmart controller in a Cisco SD-WAN environment?

Refer to the exhibit. Refer to the exhibit. What is the result of the configuration?

You issue the debug ppp authentication command on RouterA. RouterA’s Serial 0/0 interface is connected to RouterB. RouterA’s Serial 0/1 interface is connected to RouterC. You issue the no shutdown command on all interfaces and note that every interface has entered the up state. Next, you issue the show debug condition command on RouterA and receive the following output: Which of the following statements is true? (Select the best answer.)

You issue the show ip ospf neighbor command on a Cisco router. The router’s OSPF neighbor state is FULL/DR. Which of the following is most likely true about the OSPF router? (Select the best answer.)

You issue the ip as-path access-list 1 permit ^7_23$ command on a BGP router. Which of the following paths are allowed by the AS path filter? (Select the best answer.)

Topic 1An engineer is describing QoS to a client.Which two facts apply to traffic policing? (Choose two.)

Which of the following does not cause a GRE tunnel endpoint on a Cisco device to enter the Up/down state? (Select the best answer.)

You issue the ping 192.168.1.1 size 1501 dfbit command on a Cisco device. You notice a message indicating that the DF bit has been set. However, the ping fails. You want to determine the largest datagram that the connection supports without fragmentation. Which of the following should you do next? (Select the best answer.)

Refer to the Exhibit. An ertgineer must modify the existing configuration so that R2 can take over as the primary router when serial interface 0/0.1 on R1 goes down. Whtch command must the engineer apply''

Topic 1When a wired client connects to an edge switch in a Cisco SD-Access fabric, which component decides whether the clienthas access to the network?

Topic 1What are two device roles in Cisco SD-Access fabric? (Choose two.)

You issue the ping 192.168.1.1 size 1600 command on a Cisco device that is configured with the default system MTU. All pings succeed. Which of the following is most likely true? (Select the best answer.)

What is the role of vSmart in a Cisco SD-WAN environment?

Which of the following cannot be exchanged between spoke sites in a DMVPN design? (Select 2 choices.)

Which DNS lookup does an access point perform when attempting CAPWAP discovery? .

Which of the following ping command options should be enabled if you want to determine the MTU size that a given connection supports? (Select the best answer.)

Refer to the Exhibit. Refer to the Exhibit. Running the script causes the output in the exhibit. What should be the first line of the script?

Topic 1Which action is the vSmart controller responsible for in a Cisco SD-WAN deployment?

Which of the following statements is true regarding OSPF connections over a GRE tunnel? (Select the best answer.)