لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
Which task must be performed first to implement BFD in an IS-IS environment?
A. Configure BFD in an interface configuration mode
B. Disable Cisco Express Forwarding on all interfaces running routing protocols other than IS-IS
C. Configure all IS-IS routers as Level 2 devices
D. Configure BFD under the IS-IS process
عرض الإجابة
اجابة صحيحة: D
السؤال #2
Router 4 is added to the network and must be in the same area as router 1. Which NET should the engineer assign?
A. 49
B. 49
C. 49
D. 49
عرض الإجابة
اجابة صحيحة: C
السؤال #3
A network engineer is implementing NetFlow to observe traffic patterns on the network. The engineer is planning to review the patterns to help plan future strategies for monitoring and preventing congestion as the network grows. If the captures must include BGP next-hop flows, which configuration must the engineer apply to the router?
A. ip cefip flow-export version 5 bgp-nexthopip flow-export destination 192
B. ip cefip flow-export version 9 bgp-nexthopip flow-export destination 192
C. ip cefip flow-export version 5ip flow-export destination 192
D. no ip cefip flow-export version 9ip flow-export destination 192
عرض الإجابة
اجابة صحيحة: B
السؤال #4
Refer to the exhibit. This configuration is being applied on an IOS XR route. Which statement about this configuration is true?
A. It is used to create a sensor-group and has a list of YANG models for streaming
B. It is used to create a subscription to specify the streaming interval
C. It is used to identify MIB entries and has a list of YANG models
D. It is used to identify traps for SNMP polling
عرض الإجابة
اجابة صحيحة: B
السؤال #5
When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not tacking the expected path in the core. Which command do you use to quickly check path of a TE tunnel?
A. traceroute
B. show mpls traffic-engineering tunnels
C. Ping
D. traceroute mpls ipv4
عرض الإجابة
اجابة صحيحة: A
السؤال #6
Refer to the exhibits. R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2. R1 generates the above log message periodically. Based on this output, which statement is true?
A. IS-IS neighbor authentication is failing for Level 2 PDUs only
B. IS-IS neighbor authentication is failing for Level 2 first and then for Level 1 PDUs
C. IS-IS neighbor authentication is failing for Level 1 and Level 2 PDUs
D. IS-IS neighbor authentication is failing for Level 1 PDUs only
عرض الإجابة
اجابة صحيحة: AB
السؤال #7
Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?
A. the area numbers on Router 1 and Router 2 to be similar
B. the wildcard mask network statement in OSPF of Router 2
C. Router 1 to be an ABR
D. the hello timers on Router 1 and Router 2 to be different
عرض الإجابة
اجابة صحيحة: A

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.