-- Exhibit -- Exhibit -- A server administrator notices that one server is intermittently NOT being sent any HTTP requests. The server logs display no issues. The LTM Specialist notices log entries stating the node (172.16.20.1) status cycling between down and up. The pool associated with the virtual server (10.10.1.100) has a custom HTTP monitor applied. Which tcpdump filter will help trace the monitor?

-- Exhibit -- Exhibit -- A layer 2 nPath routing configuration has been deployed. A packet capture contains a client connection packet with the following properties: Source IP: Destination IP: At which two locations could the packet capture have been taken? (Choose two.)

-- Exhibit -- Exhibit -- A company uses a complex piece of client software that connects to one or more virtual servers (VS) hosted on an LTM device. The client software is experiencing issues. An LTM Specialist is tasked with finding the cause of the problem. The LTM Specialist has the tcpdump extract and knows the client software has at least one connection to a VS on port 1990. However, when a tcpdump runs on the internal VLAN, there is no record of port 1990 in the tcpdump. Why is there no record of por

-- Exhibit -- Exhibit -- An LTM Specialist is investigating reports that users are unable to perform some commands through an FTP virtual server. The LTM Specialist performs a capture on the server side of the LTM device. What is the issue with the application?

-- Exhibit -- Exhibit -- An LTM Specialist configures a virtual server that balances HTTP connections to a pool of three application servers. Approximately one out of every three connections to the virtual server fails. Which two actions will resolve the problem? (Choose two.)

-- Exhibit -- Exhibit -- Which step should an LTM Specialist take to utilize AVR?

-- Exhibit -- Exhibit -- Which pool can be removed without affecting client traffic?

-- Exhibit -- Exhibit -- An LTM Specialist is investigating reports that users are unable to perform some commands through an FTP virtual server. The users are receiving the FTP error "500 Illegal PORT command." The virtual server is configured to SNAT using automap. The LTM Specialist performs a capture on the server side of the LTM device. Why is the server returning this error?

-- Exhibit -- Exhibit -- An LTM Specialist has a virtual server set up on the LTM device as per the exhibit. The LTM Specialist receives reports of intermittent issues. Some clients are connecting fine while others are failing to connect. The LTM Specialist does a tcpdump on the relevant interfaces, with the following results extracted: What is causing the intermittent issues?

-- Exhibit -- Exhibit -- An LTM Specialist is troubleshooting a new HTTP monitor on a pool. The pool member is functioning correctly when accessed directly through a browser, although the monitor is marking the member as down. As part of the troubleshooting, the LTM Specialist has captured the monitor traffic via tcpdump. How should the LTM Specialist resolve this issue?

-- Exhibit -- Exhibit -- An HTTP monitor always marks the nodes in the pool as down. The monitor's definition and the HTTP headers from the monitor request and response are provided. What is the issue?

-- Exhibit -- Exhibit -- An LTM Specialist is working on an LTM 11.0.0 installation and has identified a security vulnerability as shown in the exhibit. The LTM Specialist is tasked with applying the latest available hotfix to resolve the problem. Which procedure resolves the problem?

-- Exhibit -- Exhibit -- A virtual server is set up on an LTM device as follows: Virtual server address 78.24.213.79 Default Persistence ProfilE. source_addr, 600s. Pool NamE. Pool1 Pool Members: 10.72.250.52:80 and 10.72.250.60:80 (both on Internal Vlan) There are several current connections to the virtual server, and pool member 10.72.250.52:80 has been set to a "Disabled" state. A tcpdump on the Internal Vlan shows traffic going to 10.72.250.52:80. How soon after the persistence table query was run can e

-- Exhibit -- Exhibit -- Which step should an LTM Specialist take next to finish upgrading to HD1.3?

-- Exhibit -- Exhibit -- The decoded TCPDump capture is a trace of a failing health monitor. The health monitor is sending the string shown in the capture; however, the server response is NOT as expected. The receive string is set to 'SERVER IS UP'. What is the solution?

-- Exhibit -- Exhibit -- An LTM Specialist configures a virtual server to load balance to a pool of FTP servers. File transfers are failing. The virtual server is configured as follows: ltm virtual ftp_vs { destination 10.10.1.103:ftp ip-protocol tcp mask 255.255.255.255 pool ftp_pool profiles { tcp { } } vlans-disabled } Which change will resolve the problem?

-- Exhibit -- Exhibit -- An LTM Specialist is troubleshooting a new HTTP monitor on a pool. The pool member is functioning correctly when accessed directly through a browser. However, the monitor is marking the member as down. The LTM Specialist captures the monitor traffic via tcpdump. What is the issue?

-- Exhibit -- Exhibit -- An LTM device is used to load balance web content over a secure channel. The developers of the web content have done a trace using an HTTP profiler application. They believe that allowing the LTM device to compress traffic to the client will improve performance. The client can utilize GZIP or deflate compression algorithms. An LTM Specialist must implement the compression. The LTM Specialist has completed the following actions: 1. Create the relevant profile. 2. Apply the relevant p

-- Exhibit -- Exhibit -- Which profile could be removed or changed on this virtual server to reduce CPU load on the LTM device without increasing server side bandwidth usage?

-- Exhibit -- Exhibit -- A client attempts to connect from a Google Chrome browser to a virtual server on a BIG-IP LTM. The virtual server is SSL Offloaded. When the client connects, the client receives an SSL error. The client receives the same errors when trying Mozilla Firefox and Internet Explorer browsers. The LTM Specialist does an ssldump on the virtual server and receives the results as per the exhibit. How should this be resolved?

-- Exhibit -- Exhibit -- An LTM Specialist is upgrading the LTM devices. Which device should be upgraded first?

-- Exhibit -- Exhibit -- Users receive an error when attempting to connect to the website https://website.com. The website has a DNS record of 195.56.67.90. The upstream ISP has confirmed that there is nothing wrong with the routing between the user and the LTM device. The following tcpdump outputs have been captured: External Vlan, filtered on IP 168.210.232.5 00:25:07.598519 IP 168.210.232.5.33159 > 195.56.67.90.https: S 1920647964:1920647964(0) win 8192 00:25:07.598537 IP 195.56

-- Exhibit -- Exhibit -- A client attempts to connect from a Google Chrome browser to a virtual server on a BIG-IP LTM. The virtual server is SSL Offloaded. When the client connects, the client receives an SSL error. After trying Mozilla Firefox and Internet Explorer browsers, the client still receives the same errors. The LTM Specialist does an ssldump on the virtual server and receives the results as per the exhibit. What is the problem?