لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت

السؤال #1
Which of the following information can be observed directly through the Probe drive test tool? (Multiple choice)
A. PUSCH, PUCCH, RACH, and sRS physical channel transmit powercorrect
B. TM modecorrect
C. Number of occupied carrierscorrect
D. UE real-time transmit power
عرض الإجابة
اجابة صحيحة: ABC
السؤال #2
Under the same coverage requirements, for the comparison between the adoption of f-band network and the adoption of d-band network, the number of stations required is;
A. More
B. Lesscorrect
C. Basically equivalent
D. Difficult to evaluate
عرض الإجابة
اجابة صحيحة: B
السؤال #3
The drive test scenario judges the success of the handover, usually based on the signaling. On the terminal side, which of the following signaling starts the handover process?
A. Measurement Control
B. Measurement Report
C. Handover Request
D. Handover Command
عرض الإجابة
اجابة صحيحة: B
السؤال #4
Which of the following channel or signal is used to cell PCI identification and cell search process?
A. PDSCH
B. PDCCH
C. PSS/SSScorrect
D. PCRCH
عرض الإجابة
اجابة صحيحة: C
السؤال #5
During the test, the bit error rate below 20% is normal.
A. True
B. Falsecorrect
عرض الإجابة
اجابة صحيحة: B
السؤال #6
Assuming other conditions are unchanged, if the power parameter PB is changed from 0 to 1, then which of the following statements is correct?
A. Cell reference signal power is increased by 3dcorrect
B. Cell reference signal power is increased by 1dB
C. Cell reference signal power is reduced by 3dB
D. Cell reference signal power is reduced by 1dB
عرض الإجابة
اجابة صحيحة: A
السؤال #7
Which of the following carrier bandwidths does LTE support? (multiple choice)
A. A40M
B. B5M
C. C15M
D. D20M
عرض الإجابة
اجابة صحيحة: BCD
السؤال #8
There are 503 PCI physical cell identifiers.
A. False
B. True
عرض الإجابة
اجابة صحيحة: A
السؤال #9
Which of the following descriptions are correct for cross-zone coverage? (Multiple choice)
A. AOver-area coverage may form 'islands', leading to dropped calls
B. BCross-area coverage may cause UE transmit power limitation, causing access failure
C. CCross-area coverage may result in unbalanced load between the cross-covered base station and surrounding base stations, resulting in low resource utilization of surrounding base stations
D. DFor LTE, cross-area coverage will not cause interference to its neighboring cells
عرض الإجابة
اجابة صحيحة: ABC
السؤال #10
Which signaling is triggered by the statistics of the number of successful establishments of the RRC connection establishment?
A. RRC connection setup
B. RRC connection request
C. RRC connection setup completecorrect
D. RRC connection reconfiguration complete
عرض الإجابة
اجابة صحيحة: C
السؤال #11
In large, medium and small cities, many streets have tall buildings on both sides. To avoid time dispersion, the cell antenna azimuth of nearby base station cannot be installed on the street.
A. Truecorrect
B. False
عرض الإجابة
اجابة صحيحة: A

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف: