E2E network device update is required for the evolution from 5G NSA networking to SA networking.

gNodeBs periodically send TPC commands to UEs over PDCCHs to control the transmit power of which of the following uplink channels or signals of UEs? (Choose All that Apply)

The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality? 'The RSRP value of the test terminal can be viewed on the GENEX Probe. A RSRP value of between -60dBm and -90dBm indicates good signal quality. Lower values indicate weaker signals, while higher values indicate stronger signals.'

5G wireless network cloudification can significantly improve the user rate.

Which of the following parameters is related to the frequency-domain position of PBCH DMRSs? PCI (Physical Cell Identity) is related to the frequency-domain position of PBCH DMRSs (Physical Broadcast Channel Demodulation Reference Signals) The PBCH DMRSs are used to demodulate the Physical Broadcast Channel (PBCH) which contains system information such as the cell identity, system bandwidth, and the downlink carrier frequency. The PBCH DMRSs are transmitted in the frequency domain, and their position is determined by the Physical Cell Identity (PCI). The PCI is a unique identifier assigned to each cell in the network, and it's used to identify the cell and its system information. So, the correct answer is B. PCI. It's worth noting that the other parameters you mentioned are also related to the 5G system information and the cell configuration. Cell ID is a unique identifier assigned to each cell, SI-RNTI (System Information RNTI) is a unique identifier assigned to the system information, and Bandwidth is the amount of frequency resources allocated to the cell.

E2E network device update is required for the evolution from 5G NSA networking to SA networking.

If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, whichof the following route configurations is more suitable?

C-band is the most popular frequency band for 5G network deployment. However, there is an imbalance between uplink and downlink coverage -- how much does this imbalance approximately amount to?

5G wireless network cloudification can significantly improve the user rate.

The mmWave range is new for NR. It supports the largest bandwidth in a cell but has poor coverage capabilities. It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.

According to 3GPP specifications, which of the following is not an RRC state in 5G?

What is the maximum number of PCIs supported by a 5G network?

In NSA networking, which of the following modes is used to anchor 5G NR?

In NSA networking, which of the following modes is used to anchor 5G NR?

What is the maximum number of PCIs supported by a 5G network?

C - band is the most popular frequency band for 5G network deployment. However, there is an imbalance between uplink and downlink coverage — how much does this imbalance approximately amount to?

SSB GSCN is the center frequency number of an NR cell.

Which of the following devices is used to implement service slicing on the 5G RAN side?

SSB GSCN is the center frequency number of an NR cell.

In NSA networking, which of the following modes is used to anchor 5G NR?

5G wireless network cloudification can significantly improve the user rate.

Which type of information about NR cells is carried in the neighboring NR cell MRs reported by UEs?(Choose all that Apply)

In NSA networking, which of the following modes is used to anchor 5G NR?

In SA networking, the mobile country code (MCC) and mobile network code (MNC) information added on the gNodeB must be consistent with the PLMN information on the core network.

The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?

In NSA networking, which of the following modes is used to anchor 5G NR?

Which of the following MML commands is used to bind a physical sector to an AAU on a gNodeB?

Which of the following actions are involved in NAS procedure management in 5G? (Choose all that Apply)

During a 5G service test, an NSA UE connects to the Probe and then accesses a 4G cell. It is found that the cell does not deliver B1 measurement configurations. Which of the following is not a possible cause for this?

Which of the following parameters is related to the frequency-domain position of PBCH DMRSs? PCI (Physical Cell Identity) is related to the frequency-domain position of PBCH DMRSs (Physical Broadcast Channel Demodulation Reference Signals) The PBCH DMRSs are used to demodulate the Physical Broadcast Channel (PBCH) which contains system information such as the cell identity, system bandwidth, and the downlink carrier frequency. The PBCH DMRSs are transmitted in the frequency domain, and their position is determined by the Physical Cell Identity (PCI). The PCI is a unique identifier assigned to each cell in the network, and it's used to identify the cell and its system information. So, the correct answer is B. PCI. It's worth noting that the other parameters you mentioned are also related to the 5G system information and the cell configuration. Cell ID is a unique identifier assigned to each cell, SI-RNTI (System Information RNTI) is a unique identifier assigned to the system information, and Bandwidth is the amount of frequency resources allocated to the cell.

5G wireless network cloudification can significantly improve the user rate.

E2E network device update is required for the evolution from 5G NSA networking to SA networking.