What is me recommended configuration to ensure link aggregation is consistent in a campus topology using VSX with two aggregation switches and downlinks to access switches?

Exhibit.Which user role will be assigned when a voice client tries to connect for the first time, but the RADIUS server is unavailable?

An AOS 10 multi-site deployment has sites with AP-only bridged SSlDs and other sites with APs and gateways operating tunneled SSiDs. Client session state sync errors exist between secure lab environments and public -facing areas at several sites.What is causing the issues?

A customer is running out of IP addresses in a network segment. What will happen if they add an additional IP subnet to the same VLAN?

A customer is deploying a new warehouse with AP-634 APs in the united States with mobile devices that can operate in the 6GHz spectrum All testing and RF analyses were performed during the POC using AP-635 APs In a different location During the deployment, they noticed fewer 6GHz channels were broadcasting in the air. Why would the AP-634 deployment have a lesser amount of broadcasting channels?

Which option shows the correct Banawidth Control for 1024 kbps down and 2048 Kops up for the SSID?A)B)C)D)

You configured" a bridged mode SSID with WPA3-Enterprise and EAP-TLS security. When you connect an Active Directory joined client that has valid client certificates. ClearPass shows the following error. What is needed to resolve this issue?

You configured a WPA3-SAE with the following MAC Authentication Role Mapping in Cloud Authentication and Policy:With further default settings assume a new Android phone is connected to the network. Which role will the client be assigned after connecting for the first time?

Exhibit.An engineer has applied the above configuration to R1 and R2 However the routers OSPF adjacency never progresses past the "EXSTART-DR" slate as shown below.Which configuration action on either router will allow R1 and R2 to progress past the "EXSTART/DR" state?

Which data transmission method provides the most efficient use of airtime for VoIP traffic?

In a WLAN network with a tunneled SSID, you see the following events in HPE Aruba Networking Central:The customer asks you to investigate log messages. What should you tell them?

Exhibit.

You configured a bridged mode SSID with WPA3-Enterprise and EAP-TLS security. When you connect an Active Directory joined client that has valid client certificates, HPE Aruba Networking ClearPass shows the following error:What is needed to resolve this issue?

You configured a WPA3 - SAE with the following MAC Authentication Role Mapping in Cloud Authentication and Policy:With further default settings assume a new Android phone is connected to the network. Which role will the client be assigned after connecting for the first time?

in a WLAN network with a tunneled SSID. you see the following events in HPE Aruba Networking Central:The customer asks you to investigate log messages What should you tell them?

Exhibit.Which would explain this issue?

A network administrator accesses HPE Aruba Networking Central and notices that visitors consume too much internet bandwidth starving employee traffic when accessing an external service. Therefore, the administrator wants to limit wireless bandwidth to 60 Mops in both directions among all users in the voice rote and no more than 10 Mops in both directions for YouTube traffic. Deep packet inspection, web content classification, and firewall visibility are enabled.Which configurations are required to accomplish this task? (Select two.)A)B)C)D)

A customer is evaluating device profiles on a CX 6300 switch. The test device has the following attribute:• MAC address=81cd9313ab31 The test device needs to be assigned the "lot - prod'' role, in addition the "lot - default" role must be applied for any other device connected lo interface 1/1/1. This is a lab environment with no configuration of any external authentication server for the test. Given the configuration example, what is required to meet this testing requirement?

A customer is planning to add loT devices that connect wirelessly to the existing 802.1X SSID. The customer will use HPE Aruba Networking ClearPass to authenticate the loT devices by MAC address but other devices will still need to authenticate by only 802.1X.Refer to the exhibit.The customer provided the current configuration and reported their non-IoT 802.1X devices are no longer able to connect. Which configuration change can be made to fix the issue?

You configured" a bridged mode SSID with WPA3-Enterprise and EAP-TLS security. When you connect an Active Directory joined client that has valid client certificates. ClearPass shows the following error. What is needed to resolve this issue? The error message 'User not found' indicates that the authentication source, in this case, Active Directory (AD), is not able to locate the user account based on the current search parameters. This often occurs when the User Principal Name (UPN) that the client is using to authenticate is not included in the search parameters of the AD authentication source within ClearPass. By modifying the AD authentication source to include the UPN in the search, ClearPass will be able to correctly locate the user account and proceed with the authentication using the valid client certificates.

You configured a tunneled SSID with captive portal and a ClearPass Guest Self Registration workflow when testing and launching the self-registration workflow, after successful registration, the login action shows the following error: What is the best solution to resolve this error?

Your customer's employees connected to a wired network are complaining about a poor user experience. The customer has UXI sensors deployed on their premises. These sensors nave been running for multiple months. They are testing both the wired network (using the wired Interface of each sensor) and the wireless networks. Your customer used the UXI dashboard to find the reason for the poor user experience to find more details, the customer asked you to check the packet captures that have been downloaded from the sensors using the UXI dashboard.From the zip file downloaded from the UXI sensors, you checked the "datagrams" .pcap file, but you were not able to find any issues How can you explain this?

You configured a bridged mode SSID with WPA3-Enterprise and EAP-TLS security. When you connect an Active Directory joined client that has valid client certificates, HPE Aruba Networking ClearPass shows the following error:What is needed to resolve this issue?

A network administrator accesses HPE Aruba Networking Central and notices that visitors consume too much internet bandwidth, starving employee traffic when accessing an external service. Therefore, the administrator wants to limit wireless bandwidth to 50 Mbps in both directions among all users in the voice role and no more than 10 Mbps in both directions for YouTube traffic. Deep packet inspection, web content classification, and firewall visibility are enabled.Which configurations are required to accomplish this task? (Choose two.)

Which command would allow you to verity receipt of a CoA message on an AOS 10 GW?