Which guidelines should an architect use to determine how many AirWave servers to recommend?

An Aruba wireless solution for a very high density (VHD) wireless solution consists of a Mobility Master (MM) and two Mobility Controllers (MCs). What is the best practice design for routing the wireless traffic?

A customer needs a solution to terminate VPN tunnels for Aruba RAPs. The customer has a single site and a single public IP address for this purpose. Networkaddress translation (NAT) will forward the IPsec traffic to the correct device to terminate the VPN tunnel. The customer also requires N+1 redundancy for thesolution. Which solution meets the customer requirements?

Refer to the exhibits.Exhibit 1 shows the logical plan, and Exhibit 2 shows the BOM created with IRIS. An architect plans to propose two 5406Rzl switches as a VSF fabric for a campus network core. Which issue with the plan should the architect correct?Exhibit 1 -Exhibit 2 -

An architect needs to plan the RF coverage. Which application has the greatest potential impact on RF design?

For which scenario does the Aruba backplane stacking technology meet the needs?

Which guidelines should an architect use to determine how many AirWave servers to recommend?

What is one reason to recommend dedicated Air Monitors (AMs) for a customer, as opposed to APs that are doing WIPS in AP mode (hybrid)?

An RF plan specifies wide sector directional antennas.Refer to the antenna specifications.H-plane refers to the Azimuth or Horizontal plane and E-plane refers to Elevation or Vertical plane.Antenna 1: H-plane = 360; E-plane = 120Antenna 2: H-plane = 360; E-plane = 60Antenna 3: H-plane = 100; E-plane = 90Antenna 4: H-plane = 60; E-plane = 60Which antenna specifications indicate that the antenna is a good choice for the plan?

A plan includes these security settings for the employee WLAN:1. WPA2-Enterprise with AES encryption2. 802.1X with PEAP-MSCHAPv2However, the customer wants to use certificates to authenticate user devices. Which change bringsthe plan inalignment with the customer requirements?

An architect needs to plan the bandwidth for two Aruba 7240 Mobility Controllers (MCs) which will connect to the network core. The customer indicates that four10 GbE links between the network core and the data center will be adequate. The customer expects almost all traffic in the network will be wireless. The customerexpects up to 25 Gbps upstream traffic from wireless clients and up to 35 Gbps downstream to wireless clients. The customer requires the MCs to be able tocontinue to forward traffic if up to one link fails, but lower performance during the failover situation is permissible.What are the minimal links to meet these requirements?

An architect needs to plan the bandwidth for two Aruba 7240 Mobility Controllers (MCs) which will connect to the network core. The customer indicates that four10 GbE links between the network core and the data center will be adequate. The customer expects almost all traffic in the network will be wireless. The customer expects up to 25 Gbps upstream traffic from wireless clients and up to 35 Gbps downstream to wireless clients. The customer requires the MCs to be able to continue to forward traffic if up to one link fails, but lower performance during the failover situation is permissible.What are the minimal links to meet these requirements?

An architect plans where to deploy new Aruba 320 Series APs at a customer site. The architect plans for the APs to be installed on the ceiling where power is inaccessible. The Ethernet cable run to these locations is CAT6, and the customer wants to support at least 1 GbE connectivity. The architect plans to connect each AP with one Ethernet port to a switch in a nearby wiring closet.

An architect has an Instant AP (IAP) cluster at a mid-sized branch office. The IAP cluster now needs totunnelcorporate traffic to a Mobility Controller (MC) at the main office. However, the branch office shouldremainfunctional even if the link to the main office fails. Users at the branch office require access to mainofficeresources, but do not require multicast services.What is the recommended DHCP mode?

A customer needs an 802.11ac upgrade for an office with cubicles. The customer states that, becausetheyplanned locations for the existing 802.11n APs so that there are no coverage holes, they will simplydeploy thenew 802.11ac APs in the same location as the existing APs. The customer plans to support mobiledevices inaddition to laptops.What should the architect explain about shy a site survey is desirable to determine the optimallocations for thenew APs?

An enterprise needs an upgrade to 802.11ac. Users run applications such as Web, email, voice, andvideo.The architect needs to conduct an active site survey to plan 802.11ac AP locations. The noise floor isabout -90 dBm across the site.Based on Aruba best practices, what is the minimum acceptable signal that the architect should lookfor todetermine the test AP range?

An architect needs to plan an 802.11ac wireless upgrade for a university building. What is one reason that it is important for the architect to identify auditoriums?

Refer to the exhibit.An architect selects 5406R switches for the aggregation layer. What is an appropriate amount ofbandwidth forthe link aggregation between each aggregation layer VSF fabric and the campus core?

A customer has very high availability requirements for wireless services. The architect plans to implement clustering on several Aruba Mobility Controllers (MCs). Which benefit of this feature should the architect explain?