A network administrator notices that SI events are not being updated. The Cisco FTD device is unable to load all of the SI event entries and traffic is not being blocked as expected. What must be done to correct this issue?

An organization has a Cisco FTD that uses bridge groups to pass traffic from the inside interfaces to the outside interfaces. They are unable to gather information about neighboring Cisco devices or use multicast in their environment. What must be done to resolve this issue?

A network security engineer must export packet captures from the Cisco FMC web browser while troubleshooting an issue. When navigating to the address https:///capture/CAPI/pcap/test.pcap, an error 403: Forbidden is given instead of the PCAP file. Which action must the engineer take to resolve this issue?

An analyst is investigating a potentially compromised endpoint within the network and pulls a host report for the endpoint in question to collect metrics and documentation. What information should be taken from this report for the investigation?

A company has many Cisco FTD devices managed by a Cisco FMC. The security model requires that access control rule logs be collected for analysis. The security engineer is concerned that the Cisco FMC will not be able to process the volume of logging that will be generated. Which configuration addresses this concern?

An engineer is troubleshooting connectivity to the DNS servers from hosts behind a new Cisco FTD device. The hosts cannot send DNS queries to servers in the DMZ. Which action should the engineer take to troubleshoot this issue using the real DNS packets?

An administrator must use Cisco FMC to install a backup route within the Cisco FTD to route traffic in case of a routing failure with the primary route. Which action accomplishes this task?

The administrator notices that there is malware present with an exe extension and needs to verify if any of the systems on the network are running the executable file. What must be configured within Cisco AMP for Endpoints to show this data?

An organization is migrating their Cisco ASA devices running in multicontext mode to Cisco FTD devices. Which action must be taken to ensure that each context on the ASA is logically separated in the FTD devices?

A Cisco FTD has two physical interfaces assigned to a BVI. Each interface is connected to a different VLAN on the same switch. Which firewall mode is the Cisco FTD set up to support?