View the exhibit, which contains the output of a BGP debug command, and then answer the question below. Which of the following statements about the exhibit are true? (Choose two.)

How are bulk configuration changes made using FortiManager CLI scripts? (Choose two.)

Which statements about bulk configuration changes using FortiManager CLI scripts are correct? (Choose two.)

Which two statements about the Security Fabric are true? (Choose two.)

Refer to the exhibit, which contains the output of the diagnose vpn tunnel list. Which command will capture ESP traffic for the VPN named DialUp_0?

An LDAP user cannot authenticate against a FortiGate device. Examine the real time debug output shown in the exhibit when the user attempted the authentication; then answer the question below. Based on the output in the exhibit, what can cause this authentication problem?

An administrator has configured two FortiGate devices for an HA cluster. While testing the HA failover, the administrator noticed that some of the switches in the network continue to send traffic to the former primary unit. The administrator decides to enable the setting link-failed-signal to fix the problem. Which statement is correct regarding this command?

Refer to the exhibit, which contains the output of a debug command. If the default settings are in place, what can be concluded about the conserve mode shown in the exhibit?

In which two states is a given session categorized as ephemeral? (Choose two.)

What does the dirty flag mean in a FortiGate session?

An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP. The output of the debug flow is shown in the exhibit: Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)

An administrator is running the following sniffer in a FortiGate: diagnose sniffer packet any “host 10.0.2.10” 2 What information is included in the output of the sniffer? (Choose two.)

View the exhibit, which contains a partial output of an IKE real-time debug, and then answer the question below. Based on the debug output, which phase-1 setting is enabled in the configuration of this VPN?

Which two statements about application-layer test commands are true? (Choose two.)

Refer to the exhibit, which shows the output of a diagnose command. What can you conclude from the output shown in the exhibit? (Choose two.)

Which three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)

Which of the following statements are true regarding the SIP session helper and the SIP application layer gateway (ALG)? (Choose three.)

Refer to the exhibits, which show the configuration on FortiGate and partial internet session information from a user on the internal network. An administrator would like to test session failover between the two service provider connections. What changes must the administrator make to force this existing session to immediately start using the other interface? (Choose two.)