لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت

السؤال #1
What are two advantages of using an IPsec recommended template to configure an IPsec tunnel in an hub-and-spoke topology? (Choose two.) The use of an IPsec recommended template offers the advantage of ensuring consistent settings between phase1 and phase2 (A), which is essential for the stability and security of the IPsec tunnel. Additionally, it guides the administrator to use Fortinet's recommended settings (B), which are designed to optimize performance and security based on Fortinet's best practices. Re
A. t ensures consistent settings between phase1 and phase2
B. t guides the administrator to use Fortinet recommended settings
C. t automatically install IPsec tunnels to every spoke when they are added to the FortiManager ADOM
D. he VPN monitor tool provides additional statistics for tunnels defined with an IPsec recommended template
عرض الإجابة
اجابة صحيحة: AB
السؤال #2
Refer to the exhibits.Exhibit A Exhibit B Exhibit A shows the source NAT (SNAT) global setting and exhibit B shows the routing table on FortiGate.Based on the exhibits, which two actions does FortiGate perform on existing sessions established over port2, if the administrator increases the static route priority on port2 to 20? (Choose two.)
A. FortiGate flags the sessions as dirty
B. FortiGate continues routing the sessions with no SNAT, over port2
C. FortiGate performs a route lookup for the original traffic only
D. FortiGate updates the gateway information of the sessions with SNAT so that they use port1 instead of port2
عرض الإجابة
اجابة صحيحة: AD
السؤال #3
Refer to the exhibits.Exhibit A Exhibit B Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.If port2 is detected dead by FortiGate, what is the expected behavior?
A. Port2 becomes alive after three successful probes are detected
B. FortiGate removes all static routes for port2
C. The administrator manually restores the static routes for port2, if port2 becomes alive
D. Host 8
عرض الإجابة
اجابة صحيحة: B
السؤال #4
Refer to the exhibits.Exhibit A Exhibit B Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
A. port1 is assigned a manual IP address
B. port1 is referenced in a firewall policy
C. port2 is referenced in a static route
D. port1 and port2 are not administratively down
عرض الإجابة
اجابة صحيحة: B
السؤال #5
Which type statements about the SD-WAN members are true? (Choose two.) SD-WAN members can be manually ordered by changing their sequence number (A), which allows administrators to prioritize the interfaces according to the routing requirements. Also, VLAN interfaces can be used as SD-WAN members (C), providing flexibility in network design and the use of existing VLAN infrastructure within the SD-WAN setup.
A. ou can manually define the SD-WAN members sequence number
B. nterfaces of type virtual wire pair can be used as SD-WAN members
C. nterfaces of type VLAN can be used as SD-WAN members
D. n SD-WAN member can belong to two or more SD-WAN zones
عرض الإجابة
اجابة صحيحة: AC
السؤال #6
Refer to the exhibit.Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)
A. FortiGate flushes all sessions
B. FortiGate terminates the old sessions
C. FortiGate does not change existing sessions
D. FortiGate evaluates new sessions
عرض الإجابة
اجابة صحيحة: CD
السؤال #7
Refer to the exhibit.Based on the output, which two conclusions are true? (Choose two.)
A. There is more than one SD-WAN rule configured
B. The SD-WAN rules take precedence over regular policy routes
C. The all_rules rule represents the implicit SD-WAN rule
D. Entry 1(id=1) is a regular policy route
عرض الإجابة
اجابة صحيحة: AD
السؤال #8
Refer to the exhibit. Which conclusion about the packet debug flow output is correct?
A. he original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped
B. he reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped
C. he original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped
D. he original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped
عرض الإجابة
اجابة صحيحة: D
السؤال #9
Refer to the exhibit.What must you configure to enable ADVPN?
A. On the hub VPN, only the device needs additional phase one sett
B. ADVPN should only be enabled on unmanaged FortiGate devices
C. Each VPN device has a unique pre-shared key configured separately on phase one
D. The protected subnets should be set to address object to all (0
عرض الإجابة
اجابة صحيحة: C
السؤال #10
Refer to the exhibit, which shows an SD-WAN zone configuration on the FortiGate GUI. Based on the exhibit, which statement is true? Based on the exhibit, the 'corporate' zone contains no member (B). In the FortiGate GUI, zones without members do not display any interfaces listed under them, which is the case for the corporate zone in the exhibit. Reference: This conclusion is based on standard Fortinet GUI interpretation and the operational logic of SD-WAN zones as per Fortinet's guidelines and user interf
A. ou can delete the virtual-wan-link zone because it contains no member
B. he corporate zone contains no member
C. ou can move port1 from the underlay zone to the overlay zone
D. he overlay zone contains four members
عرض الإجابة
اجابة صحيحة: B
السؤال #11
Which two tasks are part of using central VPN management? (Choose two.)
A. ou can configure full mesh, star, and dial-up VPN topologies
B. ou must enable VPN zones for SD-WAN deployments
C. ortiManager installs VPN settings on both managed and external gateways
D. ou configure VPN communities to define common IPsec settings shared by all VPN gateways
عرض الإجابة
اجابة صحيحة: AD
السؤال #12
Refer to the exhibit.Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
A. type must be set to static
B. mode-cfg must be enabled
C. exchange-interface-ip must be enabled
D. add-route must be disabled
عرض الإجابة
اجابة صحيحة: D
السؤال #13
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
A. Interface-based shaping mode
B. Reverse-policy shaping mode
C. Shared-policy shaping mode
D. Per-IP shaping mode
عرض الإجابة
اجابة صحيحة: A
السؤال #14
Refer to the exhibits.Exhibit A Exhibit B Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?
A. The traffic will be load balanced across all three overlays
B. The traffic will be routed over T_INET_0_0
C. The traffic will be routed over T_MPLS_0
D. The traffic will be routed over T_INET_1_0
عرض الإجابة
اجابة صحيحة: C
السؤال #15
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage ofavailable bandwidth?
A. Per-IP shaping mode
B. Reverse policy shaping mode
C. Interface-based shaping mode
D. Shared policy shaping mode
عرض الإجابة
اجابة صحيحة: D
السؤال #16
The administrator uses the FortiManager SD-WAN overlay template to prepare an SD-WAN deployment. With information provided through the SD-WAN overlay template wizard, FortiManager creates templates ready to install on spoke and hub devices. Select three templates created by the SD-WAN overlay template for a spoke device. (Choose three.) In a FortiManager SD-WAN overlay template configuration for a spoke device, the system template (A) is created to provide basic device settings. The IPsec tunnel template (C
A. ystem template
B. GP template
C. IPsec tunnel template
D. LI template
E. verlay template
عرض الإجابة
اجابة صحيحة: ACE
السؤال #17
Refer to exhibits.Exhibit A.Exhibit B.Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of theparticipating SD-WAN members.Based on the exhibits, which statement is correct?
A. The dead member interface stays unavailable until an administrator manually brings the interface back
B. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server
C. Port2 needs to wait 500 milliseconds to change the status from alive to dead
D. Check interval is the time to wait before a packet sent by a member interface considered as lost
عرض الإجابة
اجابة صحيحة: B
السؤال #18
Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?
A. old-down-time
B. ink-down-failover
C. uto-discovery-shortcuts
D. dle-timeout
عرض الإجابة
اجابة صحيحة: A
السؤال #19
An administrator is troubleshooting VoIP quality issues that occur when calling external phonenumbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and isusing two upstream links One link has random jitter and latency issues and is based on a wirelessconnectionWhich two actions must the administrator apply simultaneously on the edge FortiGate to improveVoIP quality using SD_WAN rules?
A. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
B. Choose the suitable interface based on the interface cost and weight
C. Use the performance SLA targets to detect latency and jitter instantly
D. Place the troublesome link at the top of the interface preference list
E. Configure an SD-WAN rule to load balance all traffic without VoIP
عرض الإجابة
اجابة صحيحة: AC
السؤال #20
What are the two minimum configuration requirements for an outgoing interface to be selected oncethe SD-WAN logical interface is enabled? (Choose two )
A. Specify outgoing interface routing cost
B. Configure SD-WAN rules interface preference
C. Select SD-WAN balancing strategy
D. Specify incoming interfaces in SD-WAN rules
عرض الإجابة
اجابة صحيحة: AB
السؤال #21
Refer to the exhibit. Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)
A. fter FortiGate switches to active mode, FortiGate never fails back to passive monitoring
B. uring passive monitoring, FortiGate can't detect dead members
C. ortiGate can offload the traffic that is subject to passive monitoring to hardware
D. ortiGate passively monitors the member if TCP traffic is passing through the member
عرض الإجابة
اجابة صحيحة: BD
السؤال #22
Refer to the exhibit.Which statement about the command route-tag in the SD-WAN rule is true?
A. It enables the SD-WAN rule to load balance and assign traffic with a route tag
B. It tags each route and references the tag in the routing table
C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag
D. It ensures route tags match the SD-WAN rule based on the rule order
عرض الإجابة
اجابة صحيحة: D
السؤال #23
Refer to the exhibit.Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
A. The traffic shaper drops packets if the bandwidth is less than 2500 KBps
B. The measured bandwidth is less than 100 KBps
C. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps
D. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps
عرض الإجابة
اجابة صحيحة: BC

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف: