لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
Refer to the exhibit. If the NetFlow configuration is updated to version 9, which additional piece of information can be reported?
A. IPv4 flow information
B. BGP AS information
C. IPv6 flow information
D. flow sequence numbers
عرض الإجابة
اجابة صحيحة: A
السؤال #2
Refer to the exhibit: Which statement describes this configuration?
A. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session
B. Router 1 can be remotely managed by the CLI using Telnet
C. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only
D. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration
عرض الإجابة
اجابة صحيحة: B
السؤال #3
A network engineer must configure an LDP neighborship between two newly installed routers that are located in two different offices. Router 1 is the core router in the network and it has already established OSPF adjacency with router 2. On router 1 and router 2. interface fa0/0 is configured for BFD. Which additional configuration must the engineer apply to the two devices to meet the requirement?
A. Router1(config)#int fa0/0 - Router1(config-if)#mpls ldp autoconfig Router2(config)#router ospf 1 - Router2(config-router)#mpls ip
B. Router1(config)#int fa0/0 - Router1(config-if)#mpls ip Router1(config-if)#mpls ldp discovery transport-address interface Router2(config)#int fa0/0 Router2(config- if)#mpls ip Router2(config-if)#mpls ldp discovery transport-address interface
C. Route1(config)#int fa0/0 - Router1(config-if)#mpls ldp autoconfigRouter1(config-if)#mpls ldp discovery interface Router2(config)#router ospf 1 Router2(config- router)#mpls ldp autoconfig Router2(config-if)#mpls ldp discovery interface
D. Router1(config)#int fa0/0 - Router1(config-if)#mpls ip - Router2(config)#router ospf 1 Router2(config-router)#mpls ldp autoconfig
عرض الإجابة
اجابة صحيحة: D
السؤال #4
What type of configuration is it?
A. It is configuration that requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
B. It is configuration that requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
C. It is configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
D. It is configuration that requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run
عرض الإجابة
اجابة صحيحة: D
السؤال #5
Refer to the exhibit: BGPsec is implemented on R1. R2. R3. and R4 BGP peering is established between neighboring autonomous systems Which statement about implementation is true?
A. BGP updates from the eBGP peers are appended with an additional AS path value that is statically set by the domain administrator
B. BGP updates from the iBGP peers are appended with a community of local-as
C. BGP updates from the all BGP peers are appended with a community of no export
D. BGP updates from the eBGP peers are appended with a BGPsec attribute sequence that includes a public key hash and digital signature
عرض الإجابة
اجابة صحيحة: A
السؤال #6
Refer to the exhibit: Export statistics received do not include the BGP next hop. Which statement about the NetFlow export statistics is true?
A. Only the origin AS of the source router will be included in the export statistics
B. Loopback 0 must be participating in BGP for it to be included in the export statistics
C. The origin AS and the peer-as will be included in the export statistics
D. To include the BGP next hop in the export statistics, those keywords must be included with the version 9 entry
عرض الإجابة
اجابة صحيحة: D
السؤال #7
Which two features will be used when defining SR-TE explicit path hops if the devices are using IP unnumbered interfaces? (Choose two.)
A. router ID
B. labels
C. node address
D. next hop address
E. output interface
عرض الإجابة
اجابة صحيحة: D
السؤال #8
While troubleshooting the OSPF adjacency between routers R1 and R2 an engineer noticed that both routers are stuck in the EXCHANGE/EXSTART state. What should the engineer fix to solve the ongoing issue?
A. match IPv4 addresses
B. match OSPF areas
C. match OSPF network types
D. match MTU values
عرض الإجابة
اجابة صحيحة: D
السؤال #9
Refer to the exhibit. A network administrator wants to enhance the security for SNMP for this configuration. Which action can the network administrator implement?
A. Add a community string to the existing entry
B. Maintain the configuration but switch to an encrypted password for device access through SSH
C. Re-configure to use SNMPv2 with MD5 authentication
D. Re-configure to use SNMPv3
عرض الإجابة
اجابة صحيحة: C
السؤال #10
Refer to the exhibit: A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?
A. It enables peer 192
B. It enables peer 192
C. It enables peer 192
D. It enables peer 192
عرض الإجابة
اجابة صحيحة: C
السؤال #11
Refer to the exhibit: An engineer is preparing to implement link aggregation configuration. Which statement al about this configuration is true?
A. The switch port actively sends packets to negotiate an EtherChannel using PAgP
B. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode
C. The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer
D. The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer
عرض الإجابة
اجابة صحيحة: C
السؤال #12
Which service is a VNF role?
A. Compute
B. Network
C. Firewall
D. Storage
عرض الإجابة
اجابة صحيحة: D
السؤال #13
What is the role of NFVI?
A. domain name service
B. intrusion detection
C. monitor
D. network address translation
عرض الإجابة
اجابة صحيحة: D
السؤال #14
Refer to the exhibit. What is significant about the number 2 in the configuration?
A. It indicates two SNMP managers can read and write with the agent using community string ciscotest
B. It dictates the number of sessions that can be open with the SNMP manager
C. It is the numeric name of the ACL that contains the list of SNMP managers with access to the agent
D. It represents the version of SNMP running
عرض الإجابة
اجابة صحيحة: A

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.