لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
An administrator with the Super_User profile is unable to log in to FortiManager because of an authentication failure message. Which troubleshooting step should you take to resolve the issue?
A. Make sure FortiManager Access is enabled in the administrator profile
B. Make sure Offline Mode is disabled
C. Make sure the administrator IP address is part of the trusted hosts
D. Make sure ADOMs are enabled and the administrator has access to the Global ADOM
عرض الإجابة
اجابة صحيحة: BC
السؤال #2
- (Topic 3) What does a policy package status of Modified indicate?
A. FortiManager is unable to determine the policy package status
B. The policy package was never imported after a device was registered on FortiManager
C. The Policy configuration has been changed on a managed device and changes have not yet been imported into FortiManager
D. The Policy package configuration has been changed on FortiManager and changes have not yet been installed on the managed device
عرض الإجابة
اجابة صحيحة: B
السؤال #3
Which two statements about the output are true? (Choose two.)
A. The latest revision history for the managed FortiGate does match with the FortiGate running configuration
B. Configuration changes have been installed to FortiGate and represents FortiGate configuration has been changed
C. The latest history for the managed FortiGate does not match with the device-level database
D. Configuration changes directly made on the FortiGate have been automatically updated to device-leveldatabase
عرض الإجابة
اجابة صحيحة: C
السؤال #4
- (Topic 3) An administrator would like to authorize a newly-installed AP using AP Manager. What steps does the administrator need to perform to authorize an AP?
A. Authorize the new AP using AP Manager and wait until the change is updated on the FortiA
B. Changes to the AP's state do not require installation
C. Changes to the AP's state must be performed directly on the managed FortiGate
D. Authorize the new AP using AP Manager and install the policy package changes on the managed FortiGate
E. Authorize the new AP using AP Manager and install the device level settings on the managed FortiGate
عرض الإجابة
اجابة صحيحة: A
السؤال #5
- (Topic 3) An administrator would like to create an SD-WAN using central management. What steps does the administrator need to perform to create an SD-WAN using central management?
A. First create an SD-WAN firewall policy, add member interfaces to the SD-WAN template and create a static route
B. You must specify a gateway address when you create a default static route
C. Remove all the interface references such as routes or policies
D. Enable SD-WAN central management in the ADOM, add member interfaces, create a static route and SDWAN firewall policies
عرض الإجابة
اجابة صحيحة: D
السؤال #6
An administrator run the reload failure command: diagnose test deploymanager reload config on FortiManager. What does this command do?
A. It downloads the latest configuration from the specified FortiGate and performs a reload operation on the device database
B. It installs the latest configuration on the specified FortiGate and update the revision history database
C. It compares and provides differences in configuration on FortiManager with the current running configuration of the specified FortiGate
D. It installs the provisioning template configuration on the specified FortiGate
عرض الإجابة
اجابة صحيحة: AC
السؤال #7
- (Topic 3) What will happen if FortiAnalyzer features are enabled on FortiManager?
A. FortiManager will keep all the logs and reports on the FortiManager
B. FortiManager will enable ADOMs to collect logs automatically from non-FortiGate devices
C. FortiManager will install the logging configuration to the managed devices
D. FortiManager can be used only as a logging device
عرض الإجابة
اجابة صحيحة: BD
السؤال #8
Which of the following statements are true regarding VPN Gateway configuration in VPN Manager? (Choose two.)
A. Managed gateways are devices managed by FortiManager in the same ADOM
B. External gateways are third-party VPN gateway devices only
C. Protected subnets are the subnets behind the device that you don’t want to allow access to over the IPsec VPN
D. Managed devices in other ADOMs must be treated as external gateways
عرض الإجابة
اجابة صحيحة: D
السؤال #9
When an installation is performed from FortiManager, what is the recovery logic used between FortiManager and FortiGate for an FGFM tunnel?
A. After 15 minutes, FortiGate will unset all CLI commands that were part of the installation that caused the tunnel to go down
B. FortiManager will revert and install a previous configuration revision on the managed FortiGate
C. FortiGate will reject the CLI commands that will cause the tunnel to go down
D. FortiManager will not push the CLI commands as a part of the installation that will cause the tunnel to go down
عرض الإجابة
اجابة صحيحة: A
السؤال #10
- (Topic 3) Which of the following statements are true regarding schedule backup of FortiManager? (Choose two.)
A. Backs up all devices and the FortiGuard database
B. Does not back up firmware images saved on FortiManager
C. Supports FTP, SCP, and SFTP
D. Can be configured from the CLI and GUI
عرض الإجابة
اجابة صحيحة: D
السؤال #11
- (Topic 3) You ate using the Quick install option to install configuration changes on the managed FortiGate Which two statements correctly describe the result? (Choose two)
A. It installs device-level changes on the FortiGate device without launching the Install Wizard
B. It installs all the changes in the device database first and the administrator must reinstall the changes on the FodiGate device
C. It provides the option to preview only the policy package changes before installing them
D. It install provisioning template changes on the FortiGate device
عرض الإجابة
اجابة صحيحة: CD
السؤال #12
- (Topic 3) What is the advantage of using FortiManager to manage PortiAnalyzer?
A. It allows FortiManager to manage all FortiGate devices
B. It allows FortiManager to fun reports based on FortiAnalyzer
C. It allows FortiManager to store all managed FortiGate device logs
D. It allows FortiManager to act as a collector and FortiAnalyzer device
عرض الإجابة
اجابة صحيحة: AD
السؤال #13
Which two settings must be configured for SD-WAN Central Management? (Choose two.)
A. SD-WAN must be enabled on per-ADOM basis
B. You can create multiple SD-WAN interfaces per VDOM
C. When you configure an SD-WAN, you must specify at least two member interfaces
D. The first step in creating an SD-WAN using FortiManager is to create two SD-WAN firewall policies
عرض الإجابة
اجابة صحيحة: C

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.