لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
Which two configurations are needed to get the WAN Edges registered with the controllers when certificates are used? (Choose two)
A. Generate a CSR manually within vManage server
B. Generate a CSR manually on the WAN Edge
C. Request a certificate manually from the Enterprise CA server
D. Install the certificate received from the CA server manually on the WAN Edge
E. Install the certificate received from the CA server manually on the vManage
عرض الإجابة
اجابة صحيحة: B
السؤال #2
Which attributes are configured to uniquely Identify and represent a TLOC route?
A. system IP address, link color, and encapsulation
B. firewall, IPS, and application optimization
C. site ID, tag, and VPN
D. origin, originator, and preference
عرض الإجابة
اجابة صحيحة: D
السؤال #3
Which command on a WAN Edge device displays the information about the colors present in the fabric that are learned from vSmart via OMP?
A. show omp peers
B. show omp route
C. show omp sessions
D. show omp tlocs
عرض الإجابة
اجابة صحيحة: D
السؤال #4
What is a benefit of the application-aware firewall?
A. It blocks traffic by MAC address
B. It blocks traffic by MTU of the packet
C. It blocks traffic by application
D. It blocks encrypted traffic
عرض الإجابة
اجابة صحيحة: C
السؤال #5
What does the BFD value of 8 represent?
A. number of BFD sessions
B. hello timer of BFD session
C. poll-interval of BFD session
D. dead timer of BFD session
عرض الإجابة
اجابة صحيحة: D
السؤال #6
In which device state does the WAN edge router create control connections, but data tunnels are not created?
A. valid
B. backup
C. active
D. staging
عرض الإجابة
اجابة صحيحة: C
السؤال #7
How is TLOC defined?
A. It is represented by a unique identifier to specify a site in as SD-WAN architecture
B. It specifies a Cisco SD-WAN overlay in a multitenant vSMART deployment
C. It is a unique collection of GRE or iPsec encapsulation, link color, and system IP address
D. It is represented by group of QoS policies applied to a WAN Edge router
عرض الإجابة
اجابة صحيحة: A
السؤال #8
When a WAN Edge device joins the SD-WAN overlay, which Cisco SD-WAN components orchestrates the connection between the WAN Edge device and a vSmart controller?
A. vManage
B. vBond
C. OMP
D. APIC-EM
عرض الإجابة
اجابة صحيحة: BC
السؤال #9
In an AWS cloud, which feature provision WAN Edge routers automatically in Cisco SD-WAN?
A. Cloud app
B. Cloud OnRamp
C. vAnalytics
D. Network Designer
عرض الإجابة
اجابة صحيحة: C
السؤال #10
A network administrator is creating an OMP feature template from the vManage GUI to be applied to WAN edge routers. Which configuration attribute will avoid the redistribution of the routes back into the OMP from the LAN side?
A. configure "Number of Paths Advertised per Prefix"
B. configure "Overlay AS Number"
C. configure "Send Backup Paths"
D. configure "ECMP limit"
عرض الإجابة
اجابة صحيحة: B
السؤال #11
Which software security feature is supported by the Cisco ISR 4451 router?
A. IPsec/GRE cloud proxy
B. reverse proxy
C. Enterprise Firewall with Application Awareness
D. Cloud Express service
عرض الإجابة
اجابة صحيحة: A
السؤال #12
An engineer configured OMP with an overlay-as of 10666. What is the AS-PATH for prefix 104.104.104.104/32 on R100?
A. 100 10666
B. 100 20 104
C. 100 10666 20 104
D. 100 10666 104
عرض الإجابة
اجابة صحيحة: B
السؤال #13
What is a requirement for a WAN Edge to reach vManage, vBond, and vSmart controllers in a data center?
A. IGP
B. QoS
C. TLS
D. OMP
عرض الإجابة
اجابة صحيحة: A
السؤال #14
When VPNs are grouped to create destination zone in Zone-Based Firewall, how many zones can a single VPN be part of?
A. two
B. four
C. one
D. three
عرض الإجابة
اجابة صحيحة: B
السؤال #15
Which command verifies a policy that has been pushed to the vEdge router?
A. vSmart# show running-config policy
B. vEdge# show running-config data policy
C. vSmart# show running-config apply policy
D. vEdge# show policy from-vsmart
عرض الإجابة
اجابة صحيحة: D
السؤال #16
Which protocol is configured on tunnels by default to detect loss, latency, jitter, and path failures in Cisco SD-WAN?
A. TLS
B. BFD
C. OMP
D. BGP
عرض الإجابة
اجابة صحيحة: A
السؤال #17
An administrator is configuring a policy in addition to an existing hub-and-spoke policy for two sites that should directly communicate with each other. How is this policy configured?
A. hub-and-spoke
B. mesh
C. import existing topology
D. custom control (route and TLOC)
عرض الإجابة
اجابة صحيحة: B

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.