لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
Which statement is correct about the FE80;:/10 prefix?
A. This prefix range is used for the link local address
B. This prefix range is used on the loopback interface
C. This prefix range is reserved for multicast applications
D. This prefix range is not reserved
عرض الإجابة
اجابة صحيحة: A
السؤال #2
Exhibit Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit? (Choose two.)
A. R2 will perform a lookup using the mpls
B. R1 will perform a lookup using the lnet
C. R1 will perform a lookup using the mpls
D. R2 will perform a lookup using the inet
عرض الإجابة
اجابة صحيحة: B
السؤال #3
Exhibit You configured interface ge-0/070.0 to run IS-IS. but this interface does not appear in the output of the show isis adjacency command as shown in the exhibit. What is the problem in this scenario?
A. This is a Gigabit Ethernet interface, that is incompatible with the reference-bandwidth 100g statement
B. The family iso statement must be added to the logical interface
C. The router at the other end of the link Is not sending any IS-IS Hello messages
D. The router at the other end of the link is a Level 1 only router
عرض الإجابة
اجابة صحيحة: D
السؤال #4
Exhibit Referring to the exhibit, what will happen to untagged frames?
A. The untagged frames are dropped
B. The untagged frames are load balanced between VLAN 10 and VLAN 20
C. The untagged frames are associated with VLAN 10
D. The untagged frames are associated with VLAN 20
عرض الإجابة
اجابة صحيحة: A
السؤال #5
Exhibit You want the R1 and R3 routers to forward traffic destined to the 203.0.113.0/24 network through R2. Which BGP attribute would you modify to satisfy this requirement?
A. community
B. origin
C. MED
D. local preference
عرض الإجابة
اجابة صحيحة: B
السؤال #6
Exhibit S Exhibit LSI1 A AS 65501 ISPB AS 65502 Advertised Prefixes: 172.20.0.0/24 172.20.20.0/24 172.20.21.0/24 \ N Advertised Prefixes: 172.20.0.0/24 172.20.1.0/24 Referring to the exhibit, which two statements are correct? (Choose two.)
A. Devices in AS 65512 will prefer ISP A for traffic destined to the 172
B. Devices In AS 65512 will prefer ISP A for traffic destined to the 172
C. Devices in AS 65512 will prefer ISP B for traffic destined to the 172
D. Devices In AS 65512 will prefer ISP B for traffic destined to the 172
عرض الإجابة
اجابة صحيحة: CD
السؤال #7
Which LSA type does an OSPF ABR use to advertise external routes generated by an NSSAASBR into the backbone?
A. Type 5
B. Type 7
C. Type 3
D. Type 1
عرض الإجابة
اجابة صحيحة: AD
السؤال #8
Which two LSA types are permuted in OSPF totally stubby areas? (Choose two.)
A. Type 1
B. Type 3
C. Type 5
D. Type 7
عرض الإجابة
اجابة صحيحة: C
السؤال #9
The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)
A. The first usable label is 10,001
B. The last usable label is 10
C. The last usable label is 10,499
D. The first usable label Is 10,000
عرض الإجابة
اجابة صحيحة: C
السؤال #10
Exhibit You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses. Which two tasks will accomplish your objective? (Choose two.)
A. Issue the sec protocols ospf area 0
B. Under the [edit routing-options] hierarchy, configure a 32-bit router ID
C. issue the set protocols ospf3 area 0
D. Under the [edit routing-options] hierarchy, configure a 128-bit router ID
عرض الإجابة
اجابة صحيحة: CD
السؤال #11
Which BGP attribute Is used to detect touting loops?
A. AS path
B. MED
C. local preference
D. next hop
عرض الإجابة
اجابة صحيحة: C
السؤال #12
What are two types of SlDs used in segment touting? (Choose two.)
A. node
B. adjacency
C. link
D. interface
عرض الإجابة
اجابة صحيحة: AB
السؤال #13
Which two statements are correct about IS-IS? (Choose two.)
A. A level 1 only router can never form an adjacency with a level 2 only router
B. For level 2 adjacencies, the area IDs can be different
C. For level 2 adjacencies, the area IDs must be the same
D. A level 1 only router can form an adjacency with a level 2 only router
عرض الإجابة
اجابة صحيحة: D
السؤال #14
What are two bridging concepts that are used to maintain an Ethernet switching table? (Choose two.)
A. learning
B. exporting
C. aging
D. timing
عرض الإجابة
اجابة صحيحة: A
السؤال #15
Exhibit Routers R1 and R4 have a VRRP priority of 90, while R2 and R3 have default VRRP priorities Referring to the exhibit, which router will be elected as the primary VRRP router?
A. R3
B. R4
C. R2
D. R1
عرض الإجابة
اجابة صحيحة: D
السؤال #16
What Is a key differentiator of generate routes from aggregate routes?
A. Generate routes use a forwarding next hop
B. Generate routes have a default next-hop value of reject
C. Generate routes have a default preference value of 210
D. Generate routes cannot be used as a gateway of last resort
عرض الإجابة
اجابة صحيحة: B
السؤال #17
Exhibit Referring to the exhibit, which two statements are correct? (Choose two.)
A. Prefixes in Level 1 will be redistributed to Level 2
B. Prefixes In Level 2 will be not redistributed to Level 1
C. Prefixes in Level 2 will be redistributed to Level 1
D. Prefixes in Level 1 will not be redistributed to Level 2
عرض الإجابة
اجابة صحيحة: A

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.