Which configuration selling prohibits a static route from being redistributed by a dynamic routing protocol?

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority has been configured. Which statement is true in this scenario?

Which statement describes integrated routing and bridging (IRB) interfaces?

Which two interface types are used as tunnel endpoints? (Choose two.)

You are bringing a new network online with three IS-IS routers using default Junos election priorities. The routers are configured as Level 2 only IS-IS routers. Which statement is true about the DIS election in this scenario? A router's priority for becoming the designated router is indicated by an arbitrary number from 0 through 127, which you configure on the IS-IS interface. The router with the highest priority becomes the designated router for the area (Level 1, Level 2, or both), also configured on th

Exhibit Referring to the exhibit, which two statements are correct? (Choose two.)

You are troubleshooting two OSPF routers that have an adjacency that remains in the ExStart state. What would cause this problem? https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-12.html#anc13 Neighbors Stuck in Exstart/Exchange State The problem occurs most frequently when you attempt to run OSPF between a Cisco router and another vendor router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces do not match. If the router

How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?

Exhibit button Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

You are deploying link aggregation groups.

You are asked to configure filter-based forwarding on a Junos device. Which two statements are correct in this scenario? (Choose two.) To configure filter-based forwarding, perform the following tasks: Create a match filter on the ingress device. To specify a match filter, include the filter filter-name statement at the [edit firewall] hierarchy level. A packet that passes through the filter is compared against a set of rules to classify it and to determine its membership in a set. Once classified, the pack

Which two interface types are used as tunnel endpoints? (Choose two.) tunnel-end-point name { ipv4 { source-address 10.255.1.1; destination-address 10.255.2.0/25; } gre { key 9; } } https://www.juniper.net/documentation/us/en/software/junos/routing-policy/topics/ref/statement/tunnel-end-point-edit-firewall.html

You are implementing traffic engineering in your MPLS network. You must ensure that the MPLS routes are used to traverse your network. Your solution should not affect IGP routes in your route tables. In this scenario, which traffic engineering setting will accomplish this behavior? bgp---On BGP destinations only. Ingress routes are installed in the inet.3 routing table. bgp-igp---On both BGP and IGP destinations. Ingress routes are installed in the inet.0 routing table. If IGP shortcuts are enabled, the sho

You are asked to configure an LSP which uses the OSPF link state database for path computations. Which two statements are correct in this scenario? (Choose two.)

Exhibit Which two statements ate correct about the information shown in the exhibit? (Choose two.)

An OSPF router does not have a router ID configured. In this scenario, which statement is correct about the router ID?

Exhibit Referring to the exhibit, where should next-hop-self-policy be applied to alter the next-hop value?

Exhibit You are asked to configure the OSPF environment to prevent the DRother routers from participating in DR/BDR election. Referring to the exhibit, which command will accomplish this task?