What does the dot1x system-auth-control command do?

What must be configured on the Cisco ISE authentication policy for unknown MAC addresses/identities for successful authentication?

A network engineer must enforce access control using special tags, without re-engineering the network design.Which feature should be configured to achieve this in a scalable manner?

Which two fields are available when creating an endpoint on the context visibility page of Cisco ISE? (Choose two.)

A network engineer is configuring a network device that needs to filter traffic based on security group tags using a securitypolicy on a routed interface.Which command should be used to accomplish this task?

An engineer is configuring a virtual Cisco ISE deployment and needs each persona to be on a different node.Which persona should be configured with the largest amount of storage in this environment?

An administrator is attempting to join a new node to the primary Cisco ISE node, but receives the error message "Node is Unreachable". What is causing this error? https://www.ciscopress.com/articles/article.asp?p=2812072

A network security administrator needs a web authentication configuration when a guest user connects to the network with a wireless connection using these steps: . An initial MAB request is sent to the Cisco ISE node. . Cisco ISE responds with a URL redirection authorization profile if the user's MAC address is unknown in the endpoint identity store. . The URL redirection presents the user with an AUP acceptance page when the user attempts to go to any URL. Which authentication must the administrator config

What are two requirements of generating a single certificate in Cisco ISE by using a certificate provisioning portal, without generating a certificate signing request? (Choose two.)

What is a restriction of a standalone Cisco ISE node deployment?

In which two ways can users and endpoints be classified for TrustSec? (Choose two.)

How is policy services node redundancy achieved in a deployment?

An engineer is configuring static SGT classification. Which configuration should be used when authentication is disabled and third-party switches are in use? https://community.cisco.com/t5/security-knowledge-base/segmentation-strategy/ta-p/3757424: 'The method of sending out IP to SGT mappings from ISE is particularly useful if the access switch does not support TrustSec'

In a standalone Cisco ISE deployment, which two personas are configured on a node? (Choose two.)