Which component is similar to an EVPN instance?

DRAG DROP Drag and drop each NAT64 description from the left onto the correct NAT64 type on the right. Select and Place:

While implementing TTL security, you issue the PE(config-router-af)#neighbor 2.2.2.2 ttl-security hops 2 command. After you issue this command, which BGP packets does the PE accept?

Refer to the exhibit. Which configuration prevents the OSPF neighbor from establishing?

Which additional feature does MPLS DiffServ tunneling support?

Which statement about the Cisco MPLS TE forwarding adjacency feature is true?

Refer to the exhibit. R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1, these log messages are seen: Which command can be configured on routers R1 and R2 on f0/0 interfaces to form OSPF adjacency?

Refer to the exhibit. P3 and PE4 are at the edge of the service provider core and serve as ABR routers. Aggregation areas are on either side of the core. Which statement about the architecture is true?

You are writing an RPL script to accept routes only from certain autonomous systems Consider this code. If you apply this code to BGP filters, which effect does the code have on your router?

Refer to the exhibit. An engineer is preparing to implement data plane security configuration. Which statement about this configuration is true?

Refer to the exhibit Which effect of this configuration is true?

Refer to the exhibit. When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1. Which factor should be the reason for this situation?

A regional MPLS VPN provider operates in two regions and wants to provide MPLS L3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider can connect to these two locations. Which statement about this scenario is true?

Which BGP attribute is used first when determining the best path?

How much must the MTU be increased when configuring the 802.1q VLAN tag?

Refer to the exhibit. Based on the show command output, which result is true after BGP session is established?

Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right