لا تريد أن تفوت شيئا؟

نصائح اجتياز امتحان الشهادة

آخر أخبار الامتحانات ومعلومات الخصم

برعاية وحديثة من قبل خبرائنا

نعم، أرسل لي النشرة الإخبارية

خذ اختبارات أخرى عبر الإنترنت
السؤال #1
Which design requirement is met by implementing syslog versus SNMP?
A. when automation capabilities are needed
B. when proactive alerts for critical events must be generated
C. when organization-wide information must be collected
D. when information such as flows and client connectivity must be gathered
عرض الإجابة
اجابة صحيحة: D
السؤال #2
Refer to the exhibit. What are the Loss and Average Latency statistics based on?
A. responses that the MX appliance receives on the connectivity-testing hostnames on the Insight > Web App Health page
B. responses that the MX appliance receives on the connectivity-testing IP addresses on the Security & SD-WAN > Firewall page
C. responses that the MX appliance receives on the connectivity-testing IP address that is configured on the Security & SD- WAN > SD-WAN & Traffic Shaping page
D. responses that the MX appliance receives on the connectivity-testing IP addresses on the Help > Firewall info page
عرض الإجابة
اجابة صحيحة: B
السؤال #3
Refer to the exhibit. Refer to the exhibit. What Is the ratio of internet-bound flows that route via WAN 1 compared with WAN 2? https://documentation.meraki.com/MX/Firewall_and_Traffic_Shaping/MX_Load_Balancing_and_Flow_Preferences#Load_Balancing
A. ll flows alternate in a 5:1 ratio
B. ll flows alternate in a 2:1 ratio
C. ll flows agrees via WAN 1:1 ratio
D. ll flows egress via WAN1
عرض الإجابة
اجابة صحيحة: C
السؤال #4
For which two reasons can an organization become “Out of License”? (Choose two.)
A. licenses that are in the wrong network
B. more hardware devices than device licenses
C. expired device license
D. licenses that do not match the serial numbers in the organization
E. MR licenses that do not match the MR models in the organization
عرض الإجابة
اجابة صحيحة: BC
السؤال #5
What happens to an unsupervised iOS device when the “Meraki management” profile is removed?
A. The “Meraki management” profile is removed
B. The “Meraki management” profile is removed
C. The “Meraki management” profile is removed and then pushed automatically by Systems Manager
D. The “Meraki management” profile cannot be removed
عرض الإجابة
اجابة صحيحة: B
السؤال #6
Company iPads are enrolled in Systems Manager without supervision, and profiles are pushed through Systems Manager.Which outcome occurs when a user attempts to remove the Meraki Management profile on an iPad?
A. The “Meraki Management” profile cannot be removed
B. The Meraki Management profile is removed and then pushed automatically by Systems Manager
C. The “Meraki Management” profile is removed
D. The “Meraki Management” profile is removed
عرض الإجابة
اجابة صحيحة: C
السؤال #7
Which information do the MXs in a High Availability pair share?
A. spanning-tree state
B. time synchronization state
C. DHCP association database
D. stateful firewall database
عرض الإجابة
اجابة صحيحة: A
السؤال #8
Which Meraki Dashboard menu section is accessed to enable Sentry enrollment on an SSID?
A. Wireless > Configure > Access Control
B. Wireless > Configure > Splash page
C. Wireless > Configure > Firewall & Traffic Shaping
D. Wireless > Configure > SSIDs
عرض الإجابة
اجابة صحيحة: A
السؤال #9
Refer to the exhibit. Why does the end user complain of poor wireless performance?
A. hannel 48 utilization is at 84 percent
B. on-802
C. he client is connected to the secondary radio of the AP instead of the primary radio
D. he client is using a 20 MHz channel width to connect
عرض الإجابة
اجابة صحيحة: A
السؤال #10
Refer to the exhibit. What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
A. he MX appliance performs IDS/IPS for inter-VLAN traffic
B. he MX appliance performs AMP for inter-VLAN traffic
C. he MX appliance performs data encryption for inter-VLAN traffic
D. he MX appliance performs content filtering for inter-VLAN traffic
عرض الإجابة
اجابة صحيحة: C
السؤال #11
Which API endpoint clones a new Organization?
A. POST /organizations/clone/{organizationId}
B. PUT /organizations/{organizationId}/clone
C. POST /organizations/{organizationId}/new
D. POST /organizations/{organizationId}/clone
عرض الإجابة
اجابة صحيحة: C
السؤال #12
What are two roles of the network and device tags in a Dashboard? (Choose two.)
A. Tags enable administrators to configure a combination of network and device specific tags to create summary reports filtered for specific devices across multiple networks
B. Network tags can be used to assign networks to separate Auto VPN domains in an Organization with many networks
C. Network tags can be used to simplify the assignment of network-level permissions in an Organization with many networks
D. Device tags can be used to simplify the assignment of device-level permissions in an Organization with many administrators
E. Device tags can be assigned to MR APs to influence the gateway selection for repeaters in a mesh wireless network
عرض الإجابة
اجابة صحيحة: AE
السؤال #13
Refer to the exhibit. Which design recommendation should be considered?
A. A 25-percent throughput loss occurs for every hop
B. A 25-percent throughput loss occurs for every hop
C. A 50-percent throughput loss occurs for every hop
D. A 50-percent throughput loss occurs for every hop
عرض الإجابة
اجابة صحيحة: A
السؤال #14
Refer to the exhibit. What is the minimal Cisco Meraki Insight licensing requirement?
A. A single Meraki Insight license must be configured on network A to gain Web App Health visibility on network B
B. A single Meraki Insight license must be configured on network B to gain Web App Health visibility on network B
C. A single Meraki Insight license must be configured on network A, and a single license must be configured on network B, to gain Web App Health visibility on network B
D. Two Meraki Insight licenses must be configured on network A to gain Web App Health visibility on network B
E. Two Meraki Insight licenses must be configured on network A and a single license must be configured on network B, to gain Web App Health visibility on network B
عرض الإجابة
اجابة صحيحة: E
السؤال #15
How does a Meraki device behave if cloud connectivity is temporarily lost?
A. The offline device continues to run with its last known configuration until cloud connectivity is restored
B. The offline device reboots every 5 minutes until connection is restored
C. The offline device stops passing traffic
D. The offline device tries to form a connection with a local backup sever
عرض الإجابة
اجابة صحيحة: D
السؤال #16
Refer to the exhibit. During a Meraki AP deployment, the default SSID that the exhibit shows is broadcast.What causes this behavior?
A. An AP does not have a wired connection to the network
B. An AP cannot connect to the default gateway
C. An AP has never connected to the Meraki Cloud Controller
D. An AP has Site Survey mode enabled
عرض الإجابة
اجابة صحيحة: C
السؤال #17
Which type of authentication protocol is used when using OSPF on an MX appliance?
A. MD5
B. certificate
C. plaintext
D. SHA-1
عرض الإجابة
اجابة صحيحة: A
السؤال #18
A Cisco Meraki MX security appliance is trying to route a packet to the destination IP address of 172.18.24.12. Which routes contained in its routing table does it select? Route Priority Each type of route configured on the MX has a specific priority in comparison with other types of routes. The priority is as follows: Directly Connected Client VPN Static Routes AutoVPN Routes Non-Meraki VPN Peers BGP learned Routes NAT* https://documentation.meraki.com/MX/Networks_and_Routing/MX_Routing_Behavior
A. uto VPN route 172
B. tatic route 172
C. on-Meraki VPN route 172
D. irectly connected 172
عرض الإجابة
اجابة صحيحة: C
السؤال #19
A customer wants to use Microsoft Azure to host corporate application servers.Which feature does the customer get by using a vMX appliance rather than connecting directly to Azure by VPN?
A. malware protection
B. SD-WAN
C. next-generation firewall
D. intrusion prevention
عرض الإجابة
اجابة صحيحة: C
السؤال #20
What is out of scope when considering the Best practices for high-density wireless designs? https://documentation.meraki.com/Architectures_and_Best_Practices/Cisco_Meraki_Best_Practice_Design/Best_Practice_Design_-_MR_Wireless/High_Density_Wi-Fi_Deployments
A. aximum beamforming
B. and selection
C. inimum bitrate
D. umber of SSIDs
عرض الإجابة
اجابة صحيحة: A

عرض الإجابات بعد التقديم

يرجى إرسال البريد الإلكتروني الخاص بك والواتس اب للحصول على إجابات الأسئلة.

ملحوظة: يرجى التأكد من صلاحية معرف البريد الإلكتروني وWhatsApp حتى تتمكن من الحصول على نتائج الاختبار الصحيحة.

بريد إلكتروني:
رقم الواتس اب/الهاتف:


Copyright © 2024. Designer by SPOTO Official Website. All Rights Reserved.