

TS2-BT2
Q1:
SW400 / SW401
ip access-list extended 111
no 10
no 30
Q2:
SW111:
int e2 / 0
no ip os co 9 (the cost of the examination room for the 9, we practice the version to 100, the same principle, their attention)
Q3:
R23:
route-map MED per 10
set origin igp
route-map MED per 20
set origin incomplete
R23:
int lo0
ip os 1 a 0
Q4:
R21:
Nei DC2 roue-map LP out (examination room is not LP, pay attention to see the venue pre-match)
Q5:
R60:
int tun0
ip add 10.100.0.60 255.255.255.0
Q6:
Sw111:
int vlan 2001
ospfv3 1 ipv6 area 0
Q7:
R5
int e0 / 1
ip os 1 a 0
R10:
router ospf 65001
distance ospf external 210
Q8: (This problem is more mistakes, the first time a bug, the allocation has been configured, but is nowhere, after the preservation of the resumption of the phenomenon)
SW300 / SW301
int vlan 2000
ip dhcp relay information trusted
SW310
ip dhcp snooping information option
int po1
ip arp inspection trust
SW301
int po2
ip arp inspection trust (Remember to match, otherwise the scene can not get out, just did not check this phenomenon, check later found)
Q9:
R71 (config) #int tun0
R71 (config-if) #no ip ospf network
Q10:
R24
ip nat outside source static 201.99.70.2 201.99.25.70
Diag is a combination of H3 ++ and H3 +++
1, Q1, Q2, Q3 with the same answer H3 +
2, Q1, Q2, Q3 same as H3 +++
H1 +
SW2, SW3, SW4 vlan information is not configured, you need to configure their own. R6 and R7 BGP has been configured well, the lack of router-id, remember to make up. R16 interface is not divided into vrf, R17, R18, R19 interface has been divided. R8, R9, R10, R11 are already configured with EBGP. R12, R13, R14 bgp has been configured, but the network is not equipped.
More ccie lab battle report can view url:http://cciedump.spoto.net/rs-ccie.php
Cisco Pass Report View More >